Parts Included:(3) Laser-cut 1/8” Basswood Sheets

Tools Needed:Wood Glue or CA (cyanoacrylate)Masking TapeAssorted SandpaperOptional: Paint or Stain

Page 1 of 5 Ver. 1.0 Copyright RPP Hobby

1/10 Scale Picnic Table Kit Instructions

Instructions1. Carefully push out parts A and B from the first sheet. Sand small tabs flat if desired.

2. Assemble Table Top by gluing cross members (B) to top boards (A) per the following illustrations, making sure the laser-engraved “bolts” on the top boards are facing down and “bolts” on cross members are facing up.

3. Remove parts C and G from the second and third sheets

4. Assemble Benches by gluing cross members (G) to bench boards (C) per the following illustrations. You will need to build two Benches.

Page 2 of 5 Ver. 1.0 Copyright RPP Hobby

5. Remove and glue Legs (D) to Table Ends (F), making sure the laser-engraved line faces away from the glued area (seeillustration). You will build two table ends.

6. After glue has dried, glue two Leg Assemblies to the Top as shown.

Page 3 of 5 Ver. 1.0 Copyright RPP Hobby

7. Glue two assembled Benches to the Leg Assemblies.

8. Remove Braces (E) from sheet and glue to bottom side of Top and inside the Leg Assemblies as shown.

Page 4 of 5 Ver. 1.0 Copyright RPP Hobby

9. Allow glue to dry completely.

10. If desired, paint or stain the picnic table.

11. Enjoy!

Page 5 of 5 Ver. 1.0 Copyright RPP Hobby