Post on 19-Aug-2020
transcript
AKcent Co-Extruders
AKcent co-extruders are well suited for all extrusion applications including tubing, profiles, wire & cable, etc. A wide range of options and
cost effective customization is available.
• Full tilt from horizontal to vertical and anywhere in between
• Heavy duty double reduction gear reducer with Class 12 carburized and ground helical gearing
• Integral high quality, rear mounted thrust bearing• Feed section casting with full surround cooling and
optional field replaceable feed liners• Deep finned cast aluminum, bolt-on heaters with tight
fitting cast aluminum shrouds• High capacity barrel cooling with long life blowers• Optional heavy duty single bolt heated clamp with
titanium nitride coated hinge pins • Multiple AC vector drive and motor brands to choose
from
©2016 Graham Engineering Corporation
Features
Easy Tilt
Tilting post machines all come standard with the Easy Tilt feature. This feature makes angular adjusts quick, and accurate. Optional motorized adjustment is available.
AKcent Co-Extruders
GRAHAM ENGINEERING CORPORATION | 1203 EDEN ROAD | YORK, PA 17402-0673 USA+1 717.848.3755 | Fax +1 717.846.1931 | www.grahamengineering.com
These AKcent extruders are mounted on a tall post with a “T” shaped tripod base. The tall post enables the barrel to fully tilt from horizontal to vertical for flexible co-extrusion installations. The unique “T” base provides a narrow floor footprint and lower center of gravity for easier movement around the plant.
These AKcent extruders are mounted on a tall post with a “Y” shaped tripod base. The tall post enables the barrel to fully tilt from horizontal to vertical for flexible co-extrusion installations.
These AKcent extruders are mounted on a post with a “T” shaped tripod base. The barrel is fixed parallel to the floor (no tilting) and allows for height adjustment to match different centerline heights and/or compensate for uneven floors. The unique “T” base provides a narrow floor footprint and lower center of gravity for easier movement around the plant.
These AKcent extruders are mounted on a post with a “Y” shaped tripod base. The barrel is fixed parallel to the floor (no tilting) and allows for height adjustment to match different centerline heights and/or compensate for uneven floors.
AKcent Custom Co-Extruder Examples
Standard AKcent Co-Extruder Configurations 0.075” to 1.75”diameter, any L/D
Multiple Extruders on a Common Base
Vertical Co-Extruders
Mountable Co-Extruders with Multiple Axis of Motion
Fixed Horizontal with T-Base Fixed Horizontal with Y-Base
Full Tilt with T-Base Full Tilt with Y-Base