INSULATING COATINGS CORPORATION

ISO 9001 REGISTERED

MANUFACTURER

of the

Re-Ply Roofing &

Ceramic Coating Systems

WINNERS OF THE GREEN AWARD

AT THE 2008 GAIA AWARDS

PRESENT

What is Astec?

A water based, acrylic elastomeric ceramic coating that is fluid applied, and cures to a seamless membrane for the restoration and protection of various

substrates.

FOR MORE THAN 20 YEARS

(Since the early 60’s)

ON OVER 28 MILLION

SQUARE METERS

المناخية الظروف كافة في المناخية All-climate stability. 2استقرار الظروف كافة في المناخية All-climate stability. 2استقرار الظروف كافة في المناخية All-climate stability. 2استقرار الظروف كافة في All-climate stability. 2استقرار

All Climate Stability

ON THE OCEAN FRONT

IN THE DESERT

IN THE TROPICS

ON WALLS

ON ROOFS

ON CONCRETE

ONMETAL

STOPSLEAKS

New OrleansConvention Center

"Not only have the leaks stopped, but the level of comfort has increased….“

-R.B.C., Madison Air Parts & Supply

Sands Convention Center - Las Vegas

TREATS &

PREVENTSCORROSION

FOR COLD STORAGE

“Our engineering department reported that the plant is consuming less energy …”

-Vice President, Rainier Cold Storage & Ice

MILITARYAPPLICATIONS

US Naval Observatory

US Naval Air Museum

US Naval Air Museum

United States Air Force

“… After the application of the coating, the average peak temperature in the warehouse area dropped to 86° F, a decrease of 17° F. “

- James A., Capt. USAF Chief RSD of Civil Engineering

Before

After

United States Army

“… a 64° F reduction in roof surface temperature, a 23° F reduction in attic temperature and a 10° F reduction in room temperature as a result of the insulative and reflective value of the coating.”

- Benjamin S., Col, Dept. of the Army

Camp Robinson, North Little Rock, AR Army Reserve

US Armyin the

Middle East

• Treated Tent includes NO Sun shade on Top• Treated Tent Contains 2 split Units

• Un-treated Tent includes a Sun shade on Top• Un-treated Tent Contains 3 split Units

UN-Treated TentTemperature Reading in F AUG 6TH,2008

96.4 F � AVG

Treated TentTemperature Reading in F AUG.6TH,200885.6 F � AVG

FORWAREHOUSING

“In the past, we have struggled to maintain minus 12° F… Since the application, we have been able to maintain minus 15° F or less.”

-Plant Superintendent, Land-O-Sun Dairies

COOL WALLS

COOL ROOFS

FORINDUSTRIAL

USES

Thermal Protection

A Corrosion Barrier

“Astec is amazing, after 4 years the finish on the tanks still look great”

-President, Studer Fertilizer

Air Ducts

• Continental Airline• Disney• American Airlines• Campbell’s

ON VEHICLES

“By our own tests, we have shown a temperature reduction ranging from eight to eighteen percent in the interior ambient temperature…In the blazing Arizona sun, it (Astec) shows virtually no sign of deterioration…”

- Hal D., Director of Pupil Transportation, Scottsdale Public Schools

ON TANKS

ON WATER TANKS

“I have avoided to take a shower during noon time and after you have coated ASTEC on my water tank, no

issue of hot water in my house any more at any time of the day".

Cool Roofs = Good Economics

93 degrees Fahrenheit 178 degrees Fahrenheit

Benefits of Roof Coatings vs. Paint

Remains flexibleResists standing water Excellent adhesion to a variety of substratesResists UV exposure Applied at greater film thickness for increased

flexibilityResistances to foot traffic, i.e. tensile strengthHigher reflectivity and increased emissivity

MetalConcreteEPDM (Ethylene –Propylene-Diene-Monomer)Asphalt, Modified Bitumen, BUR Hypalon / PVCSPF (sprayed polyurethane foam)Canvas

Typically Fluid Applied Systems are selected for the following roof types:

No need to raise equipment on roof.

No need to raise equipment on roof.

Penetrations

Penetrations

Waterproof Penetrations

Maintenance Fluid Applied roof systems are seamless, require less maintenance

Conventional roof systems fail at the seams

Seams…separating

Repairing seams is standard roof maintenance on seamed roofs.

Seamless roofs require less maintenance: lower roof life-cycle costs

Seams

Tape & Waterproof seams

See Seam Sample

Metal Seams & Fasteners

Seam Preparation

Penetration details

Penetration details

Penetration details

Basecoat…multi-layer system

Finished Fluid Applied “Cool Roof”

Finished Fluid Applied “Cool Roof”

Finished Fluid Applied “Cool Roof”

Renewability / Sustainability

After ten years - extend the life an additional 10 years

At only 40 -70% of the original cost of the coating system.

Extend the usefulness of existing roofs.Protect from Ultra-violet degradation Eliminates/minimizes roof tear-off. No need to raise equipment on roof.Makes most roofs better than original.Sustainable, Renewable, lower life-cycle cost.

Fluid Applied Membranes

How it works

ENERGY SAVINGSTHROUGHREDUCED

TEMPERATURES

درع شمسي

Solar Shield

ON ROOFS

REDUCESTEMPERATURES

“…almost immediately the room temperature inside was cooled by 19° F.”

-Donald E., Yakima Ice Arena

“In the past, we have struggled to maintain minus 12° F… Since the application, we have been able to maintain minus 15° F or less.”

-Plant Superintendent, Land-O-Sun Dairies

A 7 story building is exposed to more radiation on the walls than on the roof.

A single story building receives 70% of it’s solar radiation on the roof.

Radiation Exposure SOLAR RADIATION

Solar Shield

A radiant heat barrier…

Reduces surface temperatures by as much as 20˚ C

Reflects between 80% and 87% or radiant heat

Limits radiant heat absorption between 15% and 20%

Reduces energy consumption by as much as 40%

Cool Roofing improves insulation performance

“The thermal resistance of insulation installed immediately below a black membrane has been found to be up to 30% lower than advertised, when measured at peak summertime temperatures in Austin, Texas.”

- Konopacki and Akbari, 2001

“Cool Roofs” increase insulation performance

Standard “Pink” insulation Solar reflective coating

PROVIDINGLEED CREDITS

Cool Roof Systems can qualify for 3 LEED Conditions.

Sustainable sites

Energy Management

Indoor Environmental Quality

AnENERGY STAR

PARTNER

Energy Savings

Energy Star Standard.

Initial reflectance of at least 0.65 reflectance & at least 0.5 when tested in 3 years minimum emissivity of 0.90 for a minimum of 75% of the roof surface.

LEED Condition: Sustainable Sites

LEED Condition:Energy Efficiency

Exceed ASHRAE 90.1 -2004

by 14%

Solar reflectance of 0.798 ASTEC = .87

Thermal emittance of 0.855ASTEC = .91

Added roof life-cycle cost savings for

ENERGY STAR® Fluid Applied Cool Roof Systems.

Qualified roof products maintain a more constant temperature and reduce thermal shock; cool rain/hot roof causes sharp drop in temperature, extremes of expansion and contraction.

Thermal Shock = stress and roof degradation.

•According to the EPA about $40 billion is spent annually in the United States alone to air condition buildings about 1/6 of all electricity generated in a year.

•ENERGY STAR® qualified roof products reduce the amount of air conditioning needed in buildings, and reduce energy bills by up to 50%. – Department of Energy

A reflective roof can reduce peak cooling demand by 10-15%. As a result the building owner may be able purchase a smaller, more efficient and less expensive cooling system. -EPA

Existing cooling systems will not have to work as hard to maintain the same comfort levels and may require less maintenance.

LEED Condition: Indoor Environmental Quality

Comply ASHRAE STD 55-2004

The standard specifies conditions of indoor thermal environment that occupants will find acceptable.

The standard is intended for use in design, commissioning and testing of buildings and other occupied spaces and for the evaluation of existing thermal environments.

What is Standard 55-2004?

LEED Condition:

Indoor Environmental Quality

ASHRAE STD 55-2004: Addendum F

October 2007 - IssuedNovember 2008 - Completed public review January 2009 - Board meeting for final approval

Addendum F expands roof requirements to include cool roofs.

If accepted: 1 LEED Point

EXTENDINGYOUR

FACILITY’S LIFE-CYCLE

“We can extend the life of existing roofing for a fraction of the cost of conventional roof replacement.”

- Benjamin S., Col, Dept. of the Army

Renewability / Sustainability

After ten years - extend the life an additional 10 years

At only 40 -70% of the original cost of the coating system.

Astec Benefits

• LEED credits• Sustainable / Renewable Systems• Remains flexible• Resists standing water • Excellent adhesion to a variety of substrates• Resists UV exposure / Eliminates thermal shock• Reduces surfaces temperatures• Resistance to foot traffic, i.e. tensile strength• Higher reflectivity and increased emissivity• Durable

“After we did extensive testing…it appeared that (ASTEC) would do all it was advertised to do and then some…”

-Warehouse Manager, Auvil Fruit Company

CLICK TO PLAY THE ASTEC “WHY REPLACE” VIDEO :

Length 3 Minutes

INSULATING COATINGS CORPORATION

Phone: +1.607.723.1727Website: www.icc-astec.comEmail: international@icc-astec.com