Post on 05-Feb-2021
transcript
- Activates Reverse camera input in Non MMI Audi vehicles. - Rear-view camera input. - Provides three AV Inputs. - With OE type Dynamic Parking Assistance + PDC. - On-screen display and setup.
AUDI 2008 - 2014 A4 2008 - 2014 A6 2008 - 2014 Q5
- Works on Audi vehicles with Non MMI systems (no MMI Control Knob behind the gear shifter).
1 / 10 rev.011917
Connecting the CAN Wires
Connect CAN-H-HS (Brown+Green-3Pin) of the interface to CAN High (Orange + Brown) of the car
Connect CAN-L-HS (Green-4pin) of the interface to CAN Low (Orange + Green) of the car
2 / 10 rev.011917
Connection of LCD Wires
5 / 6
1. Unplug the OE LCD cable from a monitor and connect to the supplied LVDS-IN cable. Please refer to the photo above. WARNING: The ACC wire should be at the bottom. (see arrow)
2. Connect the other end of the original LVDS IN cable to LVDS IN port of the interface.
3. Connect the supplied LVDS-OUT cable to OEM Monitor and connect the other end to the LVDS OUT port of the interface.
3 / 10 rev.011917
Connecting the CAN Wires
4. Tap the CAN High wire (green + brown) of the RVCAD-81B to the CAN High wire (orange + green) of the vehicle.
5. Tap the CAN Low wire (green) of the RVCAD-81B to the CAN Low wire (orange + brown) of the vehicle.
DIP Switch Settings
NOTE: Disconnect the Power Harness before changing the DIP Switch setting.
4 / 10 rev.011917
Remote Control
OSD Settings
Press the of the remote control for 2 seconds to enter settings.
5 / 10 rev.011917
Parking Line Setting
6 / 10 rev.011917
UTIL1 Settings
7 / 10 rev.011917
8 / 10 rev.011917
Operation
9 / 10 rev.011917
OSD (On Screen Display) Settings
10 / 10 rev.011917