Post on 05-Feb-2021
transcript
Audi A4 Cabriolet • S4 Cabriolet
Quick reference guide
Fuel(see sticker)
Tyre pressures (see sticker on door
pillar on driver side)
Fuel tank flapTo open:
Press the right side of the flap.To close:
Press the tank flap until you hearit click into place.
Engine oilThe correct oil specifi-cations and engine oil
capacity are listed inthe Performance,
weights and dimen -sions section of the
Owner’s Manual.
Warning triangleThe compartment for the warning triangle is located inside the boot lid.
Welcome
Dear Audi Driver,
This quick reference guide gives you an overview of the main features and controls of your vehicle. However, it cannot replace the detailed Owner’s Manual which contains important information and safety warnings.
Please refer to your Owner's Manual for detailed information on your vehicle.You will find everything you need toknow about the radio, CD, navigation, TVand telephone functions in the OperatingManual for your sound system or navigation system.
We wish you safe and enjoyable motoring with your new Audi.
AUDI AG
Controls anddisplays
Buttons for seat memoryElectric windowsTo set the desired position:Press/pull to the first stopand hold. „One-touch“ function:Press/pull briefly to the second stop.
Bonnet lock releaseSteering wheel position adjuster
4
3
1
2
1
2
3
4
5
6 7
8
9
10 1412 12
11 11
13
15
Door handle and central locking switch
UnlockLock
Adjuster for exterior mirrorsTurn the adjuster for:
Left exterior mirrorExterior mirror heatingRight exterior mirrorExterior mirror retraction
Press the adjuster to movethe mirror glass in the desired direction.
5
6
Overview
Air conditionerDriver’s seat heatingFront passenger’s seat heatingGear lever or selector leverfor automatic gearbox HandbrakePower-operated soft topCigarette lighter/electricalsocket
23
24
20
22
21
19
25
Windscreen wipers/washerand buttons for on-boardcomputerIgnition lockSwitches and warninglamps for:
Electronic stabilisationprogramPassenger airbag offHazard warning lights
Storage traySound system or navigation system
18
17
ESPOFF
16
15
14
16 17
18
19
20
22
23
24
25
21
Cruise control systemHeadlight range controland coming home/leavinghome function Light switchTurn signal and main beamleverControls on multi-functionsteering wheeltiptronic paddle leversInstruments and warning/indicator lamps
12
11
10
9
13
8
7
21 3
Seat adjustmentElectric seat adjustment
To adjust seat height and move seat backwards or forwards:Front of seat cushion up/downRear of seat cushion up/downSeat up/downSeat forwards/backwards
To adjust backrest:Backrest further upright/further reclinedHead restraint up/down
To adjust lumbar support:Press the appropriate part of the switch.
2
3
1
Manual seat adjustmentTo move seat backwards or forwards:Lift the lever and move the seat. Then release the lever and move the seat furtheruntil the catch engages.To adjust angle of seat cushion:Lift the lever and adjust the seat angle.To adjust seat height:Pull up or press down the lever repeatedly.To adjust lumbar support:Press the appropriate part of the switch.To adjust backrest:Take your weight off the backrest and turnthe knob.Easy entry function:Pull the lever upwards and fold the backrestforwards; then release the lever and movethe seat forwards.To adjust head restraint:Press the button on the side of the head restraint and move the head restraint up ordown. The top of the head restraint shouldbe at eye level or higher.
10
9
7
5
8
6
4
Sitting positionSit in a normal upright position and do not sit too close to the steeringwheel. If necessary, also adjust the
position of the steering wheel.
min.25 cm
4
5
67
8
9
10
First steps
Starting the engineSwitching on the ignition/starting the engineInsert the key into the ignition lock.
To switch on the ignition: Turn the key to position . The glow plugs on diesel
engines start preheating in this position.To start the engine (on vehicles withmanual gearbox): Press the clutchand turn the key to position untilthe engine starts.
To start the engine (on vehicles withautomatic gearbox): Move the selector
lever to position P or N, press the brakepedal, and turn the key to position until
the engine starts.To switch off the engine: Turn the key to position .0
2
2
1
Automatic gearboxSelector lever positionsP Parking lockR Reverse gearN Neutral
D Drive (forwards)S Sport position
To release the selector lever and engage a gear: Switch on the ignition,
press the brake pedal, and press the interlock button on the selectorlever. Move the selector lever toD or S to start driving forwards.tiptronic: To switch to manualgear selection mode, push theselector lever from position Dto the right. The gears areshown on the driver infor-mation system.
To shift up or down a gear:Briefly push the selector lever forwards orbackwards.
Air
co
nd
itio
ner
AB
Variable soft top storage box
The storage box can be raised in order toextend the luggage compartment. The soft top must be closed!To raise: Slide the lever to position .To lower: Slide the lever to position .B
A
Switches for air conditionerButtons on left: Temperature selection for left sideButtons on right: Temperature selection for right sideButtons in centre: Blower speedAutomatic modeSet the desired temperature andpress the buttonAir recirculationCirculates and filters the air in the interior of the vehicleECON modeActivates/deactivates air cooling
To deactivate the air conditionerAir to the windowsAir from the dashboard outletsAir to the footwells
ECON
AUTO
Power-operatedsoft topTo open the soft top:Switch on the ignition.Pull and hold the
switch until the soft top is fullyopen.To close the soft top:Switch on the ignition.Press and hold the
switch until the soft top is fully closed.
Technology
A
B
C
Setting up:p Take the windbreak out of the storage
bag (luggage compartment).p Fold the two side sections outwards.p Pull out the retainer pegs (left/right)
and hold the windbreak in a horizontalposition against the backrest upholstery.
p Slide the retainer pegs (left/right) allthe way into the mountings.
p Press the release catches (left/right)and slide the locking pins into themounting holes at the sides.
p Fold the vertical section of the wind-break into the fully upright position.
Removing:Follow the instructions in reverse order.
C
B
A
A
Windbreak
2
1
Cruise control systemWhen the system is switched on, the indicator lamp appears in the instrument cluster.To switch on/off: Pull/press lever .To set speed: Press button .To adjust stored speed: Press lever up(faster) or down (slower).
1
2
1
2 2
Audi Navigation System plusComponents
Driver information systemMulti-function steering wheelScroll the left thumbwheel to select a menu item in thedriver information system. Press the thumbwheel to confirm the selection.Press the MODE button to switch between the active audiosource and the navigation and telephone functions.Scroll the right thumbwheel to adjust the volume. If youpress the right thumbwheel, the last navigation cue will berepeated.
2
1
Operating logicThe operating logic for accessing the functions is always the same.
To call up the menu in a corner of the display: Pressthe corresponding button.To select: Turn the rotarypushbutton.To confirm: Press the rotarypushbutton.
A
C
B
C
A
B
3
5
7
6
6
4
DisplayFunction selector buttonsPress one of the buttons (e.g. RADIO) to activate the desired mode.
ON/OFF buttonTo switch on: Press briefly.To adjust volume: Turn.To mute: Press briefly.To switch off: Press and hold.Control buttonsTo activate one of the functions shown in the four corners of the display, press the control button for that corner of the display.
Rotary pushbuttonTo select a menu item on display :Turn the rotary pushbutton.To confirm selection:Press the rotary pushbutton.
3
7
5
6
4
3
Infotainment
8
4
5 7
6
Turn the rotary pushbutton and selectthe desired memory position.Press the rotary push button to confirm.8
7Press the control button for ”Memory”.Turn the rotary pushbutton and, ifdesired, select ”Store ”.
5
4 Press the rotary pushbutton. The nextfree position in the memory list will behighlighted.
6
Sto
rin
g a
rad
io s
tati
on
Press the RADIO function selector button.
1 Press the rotary pushbutton to confirm.3Turn the rotary pushbutton and selectthe desired station.
2
12
3
Infotainment
Press the NAV function selector button.1 Turn the rotary pushbutton and selectthe first letter of the destination town.Press the rotary pushbutton to confirm.5
4
Select ”Start route guidance” from themenu.Press the rotary pushbutton to confirm.The route will be calculated.
10
9
Turn the rotary pushbutton and select”Town/ZIP”.Press the rotary pushbutton to confirm.3
2
Repeat the above step to enter the remaining letters of the destinationtown until the name of the desired town appears on the display.
6 When you have entered the town, turnthe rotary pushbutton and select ”OK”.Press the rotary pushbutton to confirm.8
7
Sta
rtin
g t
he n
av
igati
on
syste
m GermanyM
MÜNCH-LEU…
MÜNCHAUR…
MÜNCHBERG
MÜNCHEBERGDELLIST
N
MÜNCHEN
MÜNCH-LEU…
MÜNCHAUR…
MÜNCHBERG
MÜNCHEBERGDEL
MÜNCH-LEU…
MÜNCHAUR…
MÜNCHBERG
MÜNCHEBERGDELLIST
NMÜN MÜNCHEN/MÜNCHEN (…
Centre
Germany
1
3
2
5
4
6
7
8
9
10
FunctionsEstablishing a BluetoothTM connectionfor a mobile phoneYou can quickly connect a Bluetooth mobile phone to the onboard phone system on your navigation system:p Switch on the ignition, navigation
system and mobile phone.p On your mobile phone, select the menu
that looks for Bluetooth devices (e.g.”Hands-free”).
p On the mobile phone, select ”Audi UHV”and confirm.
p Enter the PIN ”1234” on your mobilephone.
Memory cardsLoading:p Press the button to open the
display.p Insert the memory card into the reader
slot as shown in the illustration andpress in the memory card until you feel it click into place.
Removing:p Press the button to open the
display.p Press in the memory card. The card will
be released and can then be removedfrom the reader slot.
Bluetooth©
Infotainment
Warning and indicator lamps
Warning and indicator lamps
© 2007 AUDI AGAUDI AG reserves the right to alter any part of the vehicle, its equipment and technical specifications. No legal commitment can be implied by the information, illustrations or descriptions in this publication.No part of this publication may be reprinted, reproduced or translated without the written permissionof AUDI AG. All rights under the laws of copyright are expressly reserved by AUDI AG. Subject to alter ationand amendment. Concept and layout: Pfriemer GmbH. Printed in Germany.
If one of these red symbols lights up in the display while you are driving, stop the car immediately, switch off the engine and refer tothe Owner’s Manual.
Fault in the brake system
Fault in the cooling systemEngine oil pressure too low
Tyre pressure too low
Warning symbols
1) If this warning lamp lights up when driving, please contact a qualified workshop without delay.
Turn signals/hazard warning lightsElectronic stabilisationprogram (ESP)
Alternator1)
Main beam headlights
Engine management1) or
Glow plug system1)
Fault in brake system orhandbrake is applied
Emission control system
Airbag system1)
Cruise control system
Trailer turn signals
Anti-lock brake system1)
Seat belt warning lamp
Power-operated soft top
Audi A4 Cabriolet • S4 CabrioletKurzanleitung englisch 11.07282.562.684.20
www.audi.com