Beginning Next SlideBack 1 of 15 End Program

AVADAL AVADALSK-3 Rolls

Rolls Will Not Extend/Extend Slowly

Beginning Next SlideBack 2 of 15 End Program

AVADAL AVADALSK-3 Rolls

1. Are the isolation valves on SK-3 open?

Beginning Next SlideBack 3 of 15 End Program

AVADAL AVADALSK-3 Rolls

2. Are the isolation valves on SK-5, SK-5A & SK-6

modules open?

Beginning Next SlideBack 4 of 15 End Program

AVADAL AVADALSK-3 Rolls

3. Is there 650 psi at test point on SK-5, SK-5A &

SK-6 modules?

Beginning Next SlideBack 5 of 15 End Program

AVADAL AVADALSK-3 Rolls

4. Are 2 position 4 way Directional Valves M1 & M3 energized on SK-5,

SK-5A & SK-6 modules?

Beginning Next SlideBack 6 of 15 End Program

AVADAL AVADALSK-3 Rolls

5. Are Rotary Flow Dividers operating properly on SK-3

Modules?

Beginning Next SlideBack 7 of 15 End Program

AVADAL AVADALSK-3 Rolls

6. Are Cross Line Pressure Relief

Valves on module SK-3 set correctly?

Beginning Next SlideBack 8 of 15 End Program

AVADAL AVADALSK-3 Rolls

7. Is there any mechanical binding?

Beginning Next SlideBack 9 of 15 End Program

AVADAL AVADALSK-3 Rolls

Roller Segments Will Not Retract/Retract Slowly

Beginning Next SlideBack 10 of 15 End Program

AVADAL AVADALSK-3 Rolls

1. Are the isolation valves on SK-3 open?

Beginning Next SlideBack 11 of 15 End Program

AVADAL AVADALSK-3 Rolls

2. Are the isolation valves on SK-5, SK-5A & SK-6

modules open?

Beginning Next SlideBack 12 of 15 End Program

AVADAL AVADALSK-3 Rolls

3. Is there 650 psi at test point on SK-5, SK-5A &

SK-6 modules?

Beginning Next SlideBack 13 of 15 End Program

AVADAL AVADALSK-3 Rolls

4. Are 2 position 4 way Directional Valves M1 & M2 energized on SK-5,

SK-5A & SK-6 modules?

Beginning Next SlideBack 14 of 15 End Program

AVADAL AVADALSK-3 Rolls

5. Are Rotary Flow Dividers operating properly on SK-3

Modules?

Beginning Next SlideBack 15 of 15 End Program

AVADAL AVADALSK-3 Rolls

6. Is there any mechanical binding?