Post on 19-Jul-2021
transcript
Connection Guide™
SOLUTION A
SOLUTION B
SOLUTION C
Transfers audio and power through multi-pin connector found on popular speaker docks.
Transfers audio through included 3.5mm cable. Power supplied through multi-pin connector.
Transfers audio and power through optional 30-pin line-out cable. Power is supplied via USB. Audio delivered through the cable’s 3.5mm jack.
Optional cables and chargers are available from WaveJamr.com
Plug-In & Battery-Powered Docks Alarm Clocks 12v (FireWire) Docks
Cars Boats Aircraft
Audio Systemswith 3.5mm Aux Input
Audio Systems with RCA Aux InputRequires Optional 3.5mm to RCA Adapter
Audio In
Any Powered USB Port• AC Charger • DC Vehicle Charger• Battery Pack• Computer USB
Digital & Remote Speaker DocksIf WaveJamr doesn’t work when docked,
connect the 3.5mm cable from the WaveJamr to the speaker dock’s 3.5mm input.
(May require changing input source to AUX)
Any Powered USB Port
3.5mm Stereo Input
3.5mm Line-Out + 30-pin Charge CableConnect WaveJamr to a 30-pin cable (not included) that’s connected to a USB port.
Audio delivered via the 3.5mm line-out port.
Feature Comparison™
Docks & Works with all 12v FireWire Docks w/o any Extra Components
Docks & Works with 90% of 5v USB Docks w/o any Extra Components
Works with Practically Every System Ever Made with Optional Accessories
Docks & Works with Bose Portable and other Battery-Powered Speaker Docks w/o any Extra Components
Built-In Female 3.5mm Auxiliary Jack
Hi-Fi A2DP 1.2 w/aptX CODEC
Bluetooth Version 4 + aptX Technology Deliverers True Wired-Quality Sound
Next Gen CSR8645 Stereo ROM CD Quality Audio Reproduction
No Batteries or Charging Required
No Wall Plug or External Power Needed for Most Applications*
Works in any Vehicle with an Aux-In Audio Port - Land, Sea or Air*
Works with any Home Audio or Powered Speaker System*
Automatically Routes Phone Calls Back to the Handset for Privacy
No Complicated Buttons or Controls
Automatically Reconnects if You Move Out of Range and Then Return
Pass Multiple Drop & Crush Tests
Tested Wireless Range - Open Air
Size and Weight
List Price
Warranty / Tech Support
RadTechWaveJamr
BelkinF8Z492-P
dreamGEARISOUND-5200
CoolStreamBTR100
aurisfreeDa
58 feet
42x36.5x9.5mm12 grams
$39.95
Lifetime
15 feet
46x41x20mm36 grams
$49.99
1 year
18 feet
190x140x40mm204 grams
$49.99
4 months
34 feet
51x31x10mm14 grams
$39.99
1 year
29 feet
45x37x9.5mm19 grams
$39.99
1 year
* some applications may require the use of our optional cables and/or chargers
Bluetooth Pairing Guide
™
Getting Started (Apple iPhone shown - other Bluetooth-enabled devices similar)
1. Connect WaveJamr to your docking accessory
• Make sure accessory is powered ON - accessory must provide a powered dock (will charge a docked device)
• Connect with WaveJamr logo facing out
• Blue power indicator lamp should flash (upper-right corner)
• Set accessory audio volume level to 50% (can be fine-tuned later to individual taste - volume will be controlled from device)
2. Enable Bluetooth on your phone, media player or computer (popular phone OS shown)
Select Settings Select Bluetooth Switch Bluetooth ON
3. Pair your mobile phone, media player or computer with WaveJamr
WaveJamr © 2013 RadTech LLC
Tap WaveJamr Now Connected Close SettingsAudio Now Plays to WaveJamr
Bluetooth Pairing Guide [Continued]
Troubleshooting
4. Prepare to rockLaunch any
multimedia app Select a file to playSource Selector
displays current optionsSet volume to 50% initiallyNote the Source Selector
Audio volume can be controlled from device - Accessory volume can be fine-tuned to listeners taste.Best audio quality is typically obtained by setting accessory’s volume level to 60-80% - then control volume your device.
TIP:
~50 feet / 15 meters
Device will stay connected to WaveJamr within this range
If Device travels beyond this range,Device and WaveJamr will Disconnect
Device and WaveJamr will remaindisconnected until manually reconnected
once within range again
To Reconnect once back in range, navigateto Bluetooth settings and touch here Do not touch
here to reconnect
Disconnecting from WaveJamr (while in use) - Allow another device to pair, connect and use
Launch SettingsGo to General > Bluetooth
Switch Bluetooth OFF- OR -
Tap WaveJamr’s Chevron
Tap Forget this DeviceClose Settings
Device will stay connected to WaveJamr within this range
Disconnecting from WaveJamr
Launch SettingsGo to General > Bluetooth
Note:Forgetting the Device will require re-pairing if you intent to connect again at some point in the future.
Switching Bluetooth Off will preserve pairing - you’ll merely tap Connect for future use.
Usage TipsChoose Headphone profile (stereo), rather than Headset (mono), if given the option, for best sonic performance (even if speaker system is mono)Best audio quality is achieved by optimizing the volume setting on the speaker system being used - select a good-quality test track, purchased songs generally work best, set your device's volume level to 60%, then adjust speaker system volume so that the output is clean and free of amplifier hiss.Once this is done, note the speaker volume setting for future reference. If unable to reduce noise, try powering speakers from a different AC outlet.Better quality speaker and audio systems generally sound best when equalization (on transmitter) is set to Flat or None.Use of volume limiting software, including those that attempt to keep song volumes consistent (Sound Check) typically degrade audio quality
Ensure that WaveJamr is receiving power - LED in right-upper corner will flashIf unable to pair or connect, make sure that another previously paired / connected device has been disconnectedIf still unable to pair or connect, disable Bluetooth on your device - re-enable Bluetooth and attempt to pair / connect againCall or write WaveJamr support: +1 877-777-9088 / support@radtech.us
WaveJamr © 2013 RadTech LLC
Verified Speaker Systems
™
SOLUTION A: Systems with verified 30-pin compatibilityEdifier BreatheEdifier Luna5 Encore
iHome ID38SViHome iD9iHome ID91BZiHome iH150iHome iH5BiHome iP21iHome iP23iHome IP4PZC
iLive IBPD882B
Insignia NS-B3112Insignia NS-BHDIP01Insignia NS-BIPCD01Insignia NS-BIPCD02Insignia NS-CLIP01Insignia NS-CLIP02
JBL On-Stage Micro IIJBL On-Stage 4JBL On-Time
Jensen JiSS-330Jensen JiSS-550
Kicker Amphitheater
Logitech PureFi Anywhere 2Logitech S715i
Memorex M14604P (All)
Onkyo DS-A3
Philips AD300/37Philips AJ5300DPhilips DC290B/37Philips DC291/37
Skullcandy PIPE (All)
Sony ZSS3IPSony ZSS4IPSony RDPM7IPSony RDPXF 300IP
Venturer CR8030iE5
Acoustic Authority iRhythms (All Models)
Altec Lansing inMotion ClassicAltec Lansing inMotion IM-310Altec Lansing inMotion IM-600
Apple iPod Hi-FiApple Universal Dock (must be powered)
Belkin TuneCast
Bose SoundDock IBose SoundDock IIBose SoundDock 10Bose SoundDock Portable
Boston Acoustics Duo-i PlusBoston Acoustics Portable
Brookstone Boombox w/FM RadioBrookstone iDesign Cube Clock RadioBrookstone iDesign Flip Speaker DockBrookstone iDesign Power SpeakerBrookstone iDesign Tower Stereo
Dr Dre BeatBoxDr Dre BeatBox Portable
™
SOLUTION B & C: Systems that require line-out connectionPanasonic SC-BTT755 EGKPanasonic SC-SP100
Philips DCM580Philips DCM5090Philips DS7550/17Philips Fidelio
PIE Auto Integration Kit w/Aux-In (Auto)
Pioneer Crew (STZ-D10Z-R)Pioneer DEH-P490IBPioneer Duo (STZ-D10T-G)Pioneer Solo (STZ-D10S-L)
Pure Contour 100i
RCA RS2127iH
Sharp CDDH950P
Skullcandy VANDAL
Sony CMT-CX5BiPSony CMT-LX20iSony DAV-DZ870WSony ICF-C1iPMK2Sony ICF-CS15iPSony MHC-SC791Sony RDP-M5iPSony RDP-XF100iPSony XDR-S10HPi
VW Golf Factory iPod Kit w/Aux-In (Auto)
XtremeMac Tango Studio
Yamaha CRX-332
ANY AUDIO SYSTEM WITH ANAUX-IN PORT IS COMPATIBLE
Brookstone Portable Speaker Dock
B&W Zeppelin (all versions)
Dice Media Bridge w/Aux-In (Auto)
iHome iA63iHome ID37
JBL VENUE
LG LHB975
Mercedes-Benz Factory iPod Kit w/Aux-In (Auto)
Onkyo CR-545
An updated list is available at WaveJamr.com
NOT COMPATIBLE: Digital-only systems with no Aux-InGear4 Alarmdock reveal DockPanasonic SC-HC271Sony ICF-C05iPStem Time Command Mini
Yamaha CRX-330Yamaha PDX30Yamaha Pianocraft 330Yamaha TSX130