Post on 18-Jan-2018
description
transcript
doc.: IEEE 802.11-13/0720r0
Submission Slide 1
Date: 2013-07-16
Presenter:
Spatial Sharing Mechanism in 802.11aj (60GHz)
July 2013
Francois Chin
Name Company Address Phone email Francois Chin Po Shin
Institute for Infocomm Research (I2R) / CWPAN
1 Fusionopolis Way, #21-01 Connexis, Singapore
65-6408-2530
chinfrancois@i2r.a-star.edu.sg
doc.: IEEE 802.11-13/0720r0
Submission Slide 2
Author ListJuly 2013
Francois Chin
doc.: IEEE 802.11-13/0720r0
Submission
Background: 802.11ad Beamforming TXSS
• Beamforming training in 802.11ad : there are two phases for the beamforming training described in IEEE 802.11ad specification [1]: Sector level sweep (SLS) and Beam Refinement Protocol (BRP).
• SLS consists of TX sector sweep (TXSS) and RX sector sweep (RXSS)
Slide 3
PCP/AP
For the initial connection between two devices (Station (STA) and PBSS Control Point/Access Point (PCP/AP)), STA will receive with a quasi-omni-directional antenna while PCP sends a sequence of frames covering different TX sectors or vice versa.
STA
Figure 1. An example of TXSSSource: IEEE 802.11ad
July 2013
Francois Chin
doc.: IEEE 802.11-13/0720r0
Submission
Background: 802.11ad Beamforming RXSS
Slide 4
Source: IEEE 802.11ad
• A device with a simple antenna may not have enough TX gain to reach a distant receiver that is using an omni-directional receiving antenna
• RX Sector Sweep may be employed by the device with the higher performance antenna system
• Allows a simple antenna device, like a handset, to connect at greater range
Simple Antenna Device
RX Sector Sweep is used to initiate beamforming on this link
After the beamforming training, STAs know their best sector ID for transmission
Figure 2. An example of RXSS
July 2013
Francois Chin
doc.: IEEE 802.11-13/0720r0
Submission
Assume that beamforming training has been done: STAs know their best Sector ID for transmissionThe existing spatial sharing mechanism in [1]:• Spatial sharing can only be done in Service Period (SP), not Contention Based Access Period (CBAP)• Both existing SP and candidate SP need to perform measurement before usage• The mechanism is not very efficient. From PCP/AP’s perspective, it is a blind selection process.
Background: 802.11ad Spatial Sharing Mechanism
Slide 5
Figure 3. Example of spatial sharing assessment
July 2013
Francois Chin
doc.: IEEE 802.11-13/0720r0
Submission Slide 6
Assumption:• The beamforming training results between any two STAs will be kept
by PCP/AP with the best selected sector IDs.
Proposed solution:• A method to assess two pair of devices with directional transmission
that can be used concurrently for spatial sharing, based on the priori information of beamforming training results among devices in a network
The Proposed Spatial Sharing Mechanism
July 2013
Francois Chin
doc.: IEEE 802.11-13/0720r0
Submission
Assumption:• Each STA has 12 sectors with 30 degree transmission angel. • The beamforming training results are shown in Table 1 and 2 • PCP/AP has scheduled SP1 and SP2 for pair (A, B) and (C, D),
respectively. Purpose:• To recommend an initial SP for the candidate SP with pair (E,
F) from the existing SP set {SP1, SP2} for spatial sharing.
A B
C
D
13
117
5
9
8 1210
6 24
O
E 3F7
Source device a Destination device b S(a, b)A B 1A E 4A F 2B A 7B E 7B F 9E A 12E B 2E F 3F A 7F B 10F E 7
Table 1: Beamforming training results among {A, B, E, F}
Table 2: Beamforming training results among {C, D, E, F}
Source device a Destination device b S(a, b)C D 10C E 8C F 12D C 4D E 5D F 3E C 4E D 1E F 3F C 6F D 9F E 7
Slide 7
Example – Spatial Sharing in 802.11ad
Figure 4. An example of Spatial Sharing
July 2013
Francois Chin
doc.: IEEE 802.11-13/0720r0
Submission
• First, PCP/AP uses Table 1 to check whether SP1 is available for the candidate SP with pair (E, F).
• From Table 1, A and B choose Sector 1 and 7 (blue areas) to communicate with each other. E and F intend to use Sector 3 and 7, respectively.
• Neither E nor F would be affected by A, because the beamforming results show that the Sector 4 and 2 would be the best sector for A to transmit to E and F, respectively, which are different with Sector 1.
• The sector number difference between two best sectors S(A, B) and S(A, E) , denoted by δA→B, E , is calculated as 3; Similarly, δA→B, F = 1.
Thus, A’s transmission has no interference to E and F.
• However, if B is transmitting to A with Sector 7, E would be affected by B because the same Sector 7 is selected for B to transmit to A and E. In this case, δB→A, E = 0.
Therefore, the existing SP1 does Not satisfy with the condition of spatial sharing with the candidate SP with pair (E, F).
δ indicates the sector number difference between two best sectors S(a, b) and S(a, c) chosen by one source device a to two different destination devices b and c.
Slide 8
A B
C
D
13
117
5
9
8 1210
6 24
O
E 3F7
Procedure of Initial Recommendation (1/2)
Figure 4. An example of Spatial Sharing
July 2013
Francois Chin
doc.: IEEE 802.11-13/0720r0
Submission
• Second, PCP/AP uses Table 2 to check whether SP2 is available for the candidate SP with pair (E, F). Thus, we have
δC→D, E = 2 δC→D, F = 2 δD→C, E = 1 δD→C, F = 1 δE→F, C = 1 δE→F, D = 2 δF→E, C = 1 δF→E, D = 2
• Since the minimum value of the above δ’s is larger than 0, the existing SP2 can be recommended as an initial SP for the candidate SP with pair (E, F).
Slide 9
Procedure of Initial Recommendation (2/2)
A B
C
D
13
117
5
9
8 1210
6 24
O
E 3F7
Finally, PCP/AP responds to E and F the best initial recommendation with the result of SP2.
Figure 4. An example of Spatial Sharing
July 2013
Francois Chin
doc.: IEEE 802.11-13/0720r0
Submission
The Condition for Spatial Sharing• Spatial sharing condition: As long as any source STA involved in an existing
SP does not employ the same transmit sector with the one that it employs to communicate with any other STA involved in a candidate SP, and vice versa, the PCP/AP may schedule this existing SP and the candidate SP time-overlapping with each other for spatial sharing.
• Furthermore, if a pair of existing SP and candidate SP satisfies the above condition, the larger the number of difference between any two of transmit sectors employed by a source STA to communicate with its destination STA and with any other STA involved in the other SP, the more the space to implement spatial sharing and interference mitigation among them.
• Therefore, the parameter δ is considered as the criteria of the selection for the best initial slot that can be scheduled slot or contention based slot.
Slide 10
July 2013
Francois Chin
doc.: IEEE 802.11-13/0720r0
Submission
The Flow Chart of Proposed Mechanism
Slide 11
Start
End
Y
N
Y
NPCP/AP checks the next existing SPe for a candidate SPc with transmission pair (i, j) and set δ*e = 0;
For each scheduled transmission pair (x, y) in this SPe
Does any of the following cases occur between the intended transmission pair (i,j) and (x, y) ?S(x, i) == S(x, y) || S(x, j) == S(x, y) ||S(y, i) == S (y, x) || S(y, j) == S(y, x) ||S(i, x) == S(i, j) || S(i, y) == S(i, j) ||S(j, x) == S(j, i) || S(j, y) == S(j, i)
Calculate the values of δIf δ < δ*e δ*e = δ;
Finish the traverse of the existing SP set {SPe}?
Add SPe into initial recommendation set {SPe} with δ*e
Finish the traverse of the scheduled transmission set {x, y}e in this SPe?
Y
Search the best initial recommendation from {SPK} with the selection criteria of the largest δ*e
N
Figure 5. Flow chart of the proposed method for IEEE 802.11aj network
July 2013
Francois Chin
doc.: IEEE 802.11-13/0720r0
Submission
Benefits of Proposed Spatial Sharing Mechanism
• Accurate allocation of spatial sharing among pair of devices; • Fast allocation of spatial sharing among pair of devices; • Avoids unnecessary operation of measuring and report feedback
among those pair of devices that may cause interference with each other if they transmit concurrently;
• Power saving of the resource allocation for the spatial sharing as it can significantly reduce the number of pair of devices that can be used for measuring and report feedback
Slide 12
July 2013
Francois Chin
doc.: IEEE 802.11-13/0720r0
Submission
Modifications to 802.11ad• PCP/AP will be informed and updated of the results of the beamforming
training among non-PCP/non-AP STAs. • At the last step of beamforming phase, non-PCP/non-AP initiator (responder)
shall notify PCP/AP through a SSW-Report frame which contains an SSW Report field indicating Source AID, Destination AID, Sector Select, DMG Antenna Select, SNR Report, etc.
The Source AID field identifies the transmitter that is the intended initiator (responder) of beamforming. The Source AID field identifies the receiver that is the intended responder (initiator) of beamforming.
Slide 13
Figure 6. SSW-Report frame format and Initiator (Responder) Link Report field
July 2013
Francois Chin
doc.: IEEE 802.11-13/0720r0
Submission
Conclusions
• Proposed a spatial sharing mechanism to assess two pair of devices with directional transmission that can be used concurrently for spatial sharing, based on the priori information of beamforming training results among devices in a network;
• The proposed method applies to the initial recommendation of resource allocation in either scheduled slots or contention based slots, it is only a recommended procedure, instead of mandatory procedure;
Slide 14
July 2013
Francois Chin
doc.: IEEE 802.11-13/0720r0
Submission
Reference
[1] In the IEEE P802.11adTM-2012 Standard “Part 11: Wireless LAN Medium Access Control (MAC) and Physical Layer (PHY) Specifications – Amendment 3: Enhancements for Very High Throughput in the 60 GHz band,” December 2012.
Slide 15
July 2013
Francois Chin
doc.: IEEE 802.11-13/0720r0
Submission Slide 16
Thank YOU
July 2013
Francois Chin