FLEXYSTACKVACUUM

www.edfeurope.com

TRADITIONAL STACKER PROBLEMSStacking die cutted boxes the traditional way can end up into jams in the stacking hopper.The sliding of the boxes one onto the other and the big input angle in the hopper can generate hooking between box edges and slots in the lower box.

200 MM

Big angl

e

Jam point

WHY IS VACUUM STACKER THE BEST SOLUTION?Every blank is transported by top suction till the stacking point and then released right on top of the batch.• No box over box sliding • No hooking between box

VACUUM STACKER THE EDF WAY

• Zero feed interrupt batch change at full speed• Ideal to work with board with nicks in both direction• No hydraulics• Servo motors on all the movements• Full auto and fast setup

MACHINE IMPUTRound input belts for very good scraps ejection

INPUT BELTS

STRIPPING UNIT

STRIPPING UNIT

• Vibrator• RDC speed sync• Round belts• Rotating brush• Scraps transport up to the main factory belt

STRIPPING UNIT

• Stripper sliding to create access to the die mounting area

STRIPPING UNIT

• Automatic belts positioning• Automatic caliper

NEW VACUUM BELT TRANSPORT SYSTEM• Board transport with vacuum suction from the top• Steady control of the board position during movement

Sample ejection with machine in production

STACKING HOPPER

Automatic size adjusted squaring joggers on 4 sidesBoard top vacuum

transport

Non stop forksAutomatic selection

according to the board width

Smooth batch drop

COMPUTER

• Touch screen control• One programming point for the complete line including paletizer if present• Orders storing• Order sync with RDC computer

SUMMARY

• Reliable multi-up and multi-out operation with nicks• No jams caused by box against box movement• Zero feed interrupt• High speed productivity• Automatic sample ejection while run• Automatic set –up• Full line order sync• Automatic stripper

Edf Europe S.r.l.

Web: www.edfeurope.comEmail: info@edfeurope.com

Tel: +39 051 6631220Fax: +39 051 6630889

Address: Via della Meccanica, 10 – 40050 Argelato (BO) Italy