Post on 07-Jul-2020
transcript
ABB i-bus® EIB
EIB Power Supply Units
© A
BB S
TOTZ
-KO
NTA
KT G
mbH
, 200
2 -
SK 0
29 F
02
EÄn
deru
ng u
nd Ir
rtum
vor
beha
lten
Product Range Overview EIB Power Supplies
© A
BB S
TOTZ
-KO
NTA
KT G
mbH
, 200
2 -
SK 0
30 F
02
EÄn
deru
ng u
nd Ir
rtum
vor
beha
lten
! EIB Power Supply, 320 mASV/S 30.320.5
! EIB Power Supply, 640 mASV/S 30.640.5
! UninterruptibleEIB Power Supply, 640 mASU/S 30.640.1
Product Range Overview EIB Power Supplies
© A
BB S
TOTZ
-KO
NTA
KT G
mbH
, 200
2 -
SK 0
31 F
02
EÄn
deru
ng u
nd Ir
rtum
vor
beha
lten
EIB Power Supply, 320 mASV/S 30.320.5
! OutputsEIB: 1 with choke
! Rated current: 320 mA! Width: 4 modules! Reset: by disconnecting of the
the bus connectionterminal
! ConnectionsEIB: bus connection terminalMains: screw terminals
! LEDsON: output voltage o.k.
© A
BB S
TOTZ
-KO
NTA
KT G
mbH
, 200
2 -
SK 0
32 F
02
EÄn
deru
ng u
nd Ir
rtum
vor
beha
lten
EIB Power Supply, 640 mASV/S 30.640.5
! OutputsEIB: 1 with choke30 V DC: 1
! Rated current: 640 mA(sum of EIB and 30 V)
! Width: 6 modules! Reset: push button and LED! Connections
EIB: bus connection terminal30 V: connection terminalMains: screw terminals
! LEDsON: output voltage o.k.
© A
BB S
TOTZ
-KO
NTA
KT G
mbH
, 200
2 -
SK 0
33 F
02
EÄn
deru
ng u
nd Ir
rtum
vor
beha
lten
EIB Power Supply, 640 mA
SV/S 30.640.5
Connection diagrmfor the supply ofone line and anadditional mainline
Linie 1
Hauptlinie
L
LK/S 2.1
NPE
SV/S 30.640.5
VB/S2.2
VB/S4.4
DR/S 2.2
2
1
5
3
4
30 V DC
Linie 1
Hauptlinie
" Connection terminal# Line coupler$ Connector, 4-pole% Choke& Connector, 2-pole
© A
BB S
TOTZ
-KO
NTA
KT G
mbH
, 200
2 -
SK 0
34 F
02
EÄn
deru
ng u
nd Ir
rtum
vor
beha
lten
SU/S 30.640.1! Outputs
EIB: 1 with chokeBuffering: battery and temperature
sensorFault inform.: via potential free
change-over contact! Rated current: 640 mA! Width: 8 modules! Reset: push button and LED! Connections
EIB: Connection terminalMains: Screw terminalsFault inform.: Screw terminalsBattery: Screw terminals
Uninterruptible EIB Power Supply, 640 mA
© A
BB S
TOTZ
-KO
NTA
KT G
mbH
, 200
2 -
SK 0
35 F
02
EÄn
deru
ng u
nd Ir
rtum
vor
beha
lten
Uninterruptible EIB Power Supply, 640 mASU/S 30.640.1
! Up to two 12 V DC sealed lead acid batteries connectable in parallel
! Temperature controlled charging of the battery via temperature sensor
! Max. charging current: 150 / 650 mA! Max. charging time: approx. 4 times
back-up time! Back-up time: up to 16 hours
(depends on batterycapacity and outputcurrent)
! Protection of the battery! LED: Battery o.k.! The temperature sensor must
always be connected!
- +230 V OK OK
+ -12 V
+
7 8 9 10
ϑ -Code/
650 mA-
150 mA
ϑ - + - +
C > 5 Ah
Battery Back-Up
© A
BB S
TOTZ
-KO
NTA
KT G
mbH
, 200
2 -
SK 0
36 F
02
EÄn
deru
ng u
nd Ir
rtum
vor
beha
lten
Uninterruptible EIB Power Supply, 640 mASU/S 30.640.1
! Fault information via a potential free change-over contact for:
! mains failure! battery fault! overvoltage! overload/ short circuit
! Rated voltage: 230 V AC12 / 24 V DC
! Rated current: 6 A AC / 4 A DC! Output does not distinguish between
faults! Fault information is stored in the case
of an overvoltage or overload! Confirmation via reset push
button
Fault Information
5 6
µµ
4
LN
© A
BB S
TOTZ
-KO
NTA
KT G
mbH
, 200
2 -
SK 0
37 F
02
EÄn
deru
ng u
nd Ir
rtum
vor
beha
lten
Uninterruptible EIB Power Supply, 640 mASU/S 30.640.1
! „ON“ (green)Output voltage OK(EIB is in normal operation)
! „I>Imax“ (red)Blinking: overvoltage, autom. reset,
fault information storedon: overload,
fault information stored! 230 V AC OK (green)
Mains supply OK! Akku OK (green)
Battery OK
Status Displayvia LEDs
a
ABB i-bus EIB
SU/S 30.640.1
L N
1 2 3
- +230 V OK
5 6
µ
A
ON I>Imax
30 V DC
RESET
-5 °C...45 °C
230 V AC50/60 Hz
30 V DC640 mA
- +
12 V
30 V
OK
µ
4
+ -12 V
+
7 8 9 10
ϑ -Code/
650 mA-
150 mA
© A
BB S
TOTZ
-KO
NTA
KT G
mbH
, 200
2 -
SK 0
38 F
02
EÄn
deru
ng u
nd Ir
rtum
vor
beha
lten
Battery Module, 12 V DCAM/S 12.1
! Sealed lead acid battery! Rated voltage: 12 V DC! Rated capacity: 1 Ah! For buffering the EIB voltage for min.
10 minutes in combination with theSU/S 30.640.1
! Integrated temperature sensor for temperature controlled charging of the battery
! Integrated fuse (self healing)
© A
BB S
TOTZ
-KO
NTA
KT G
mbH
, 200
2 -
SK 0
39 F
02
EÄn
deru
ng u
nd Ir
rtum
vor
beha
lten
Battery Module, 12 V DC
a
ABB i-bus EIB
AM/S 12.1
30 V DC
RESET
SU/S 30.640.1
AM/S 12.11 2 3 4
7 8 9 10
ϑCode
-150 mA
++ -12 V
+ -12 V
+ϑ -Code/
650 mA-
150 mA SU/S 30.640.1
AM/S12.1
AM/S 12.1! Recommended installation:
DIN rail mounted directly abovethe SU/S 30.640.1
! Only to be used in combinationwith the SU/S 30.640.1!
! Temperature sensor must always be connected!
! For horizontal mounting indistribution boards only!
! Not to be connected in parallelwith other batteries or otherbattery modules
Connection diagram
© A
BB S
TOTZ
-KO
NTA
KT G
mbH
, 200
2 -
SK 0
40 F
02
EÄn
deru
ng u
nd Ir
rtum
vor
beha
lten
SU/S 30.640.1Sealed Lead Acid Batteries
Sealed Lead Acid Batteries and Accessories
Product Name Type Batterycapacity
Back-up time Charging time
Battery 12 V, 7 Ah SAK7 7 Ah up to 2,5 h (1 battery)up to 5 h (2 batteries parallel)
appr. 10 h (1 battery)appr. 20 h (2 batteries parallel)
Battery 12 V, 12 Ah SAK12 12 Ah up to 5,5 h (1 battery)up to 11 h (2 batteries parallel)
appr. 22 h (1 battery)appr. 44 h (2 batteries parallel)
Battery 12 V, 17 Ah SAK17 17 Ah up to 8 h (1 battery)up to 16 h (2 batteries parallel)
appr. 32 h (1 battery)appr. 64 h (2 batteries parallel)
© A
BB S
TOTZ
-KO
NTA
KT G
mbH
, 200
2 -
SK 0
41 F
02
EÄn
deru
ng u
nd Ir
rtum
vor
beha
lten
Sealed Lead Acid Batteries and AccessoriesCable Set Basic KS/K 4.1
! 4 core cable includingtemperature sensor and fuse
! Length: 2 m
Cable Set Extension KS/K 2.1! 2 core cable including fuse! Length: 2 m