Energy-Aware Scheduling with Quality of Surveillance Guarantee in Wireless Sensor Networks

transcript

U of Minnesota

DIWANS'06 1

Energy-Aware Scheduling Energy-Aware Scheduling withwith Quality of Surveillance Guarantee Quality of Surveillance Guarantee in in

Wireless Sensor NetworksWireless Sensor Networks

Jaehoon Jeong, Sarah Sharafkandi and David Du{jjeong,ssharaf,du}@cs.umn.edu

2 DIWANS'06

ContentsContents

1. Introduction

2. Related Work

3. Problem Formulation

4. Energy-Aware Sensor Scheduling

5. Optimality of Sensor Scheduling

6. QoSv-Guaranteed Sensor Scheduling

7. Sensor Scheduling for Complex Roads

8. Performance Evaluation

9. Conclusion

3 DIWANS'06

IntroductionIntroduction1. Motivation

We investigate the properties of the Linear Sensor Network (e.g., Road Network in transportation system).

These properties can be used for a variety of applications: Localization, Vehicle Detection, and Vehicle Tracking.

2. Applications of Our Sensing Scheduling Algorithm① Surveillance for Security around City’s Border② Crossroad Signal Control in Transportation System

3. Objectives① Maximization of Lifetime of Wireless Sensor Network② Control of Detection Quality

Quality of Surveillance Guarantee (QoSv)

4. Contributions① Energy-aware Sensor Scheduling feasible for Mobile Target

Detection and Tracking② QoSv-Guaranteed Sensor Scheduling for Complex Roads

4 DIWANS'06

Surveillance of City Border Roads (1/2)Surveillance of City Border Roads (1/2)

Inner BoundaryCITY

Outer Boundary

5 DIWANS'06

Surveillance of City Border Roads (2/2)Surveillance of City Border Roads (2/2)

Inner BoundaryCITY

Outer Boundary

Road Segment

S2 S3 Sn. . . . .

Sensing Coverage

6 DIWANS'06

Vehicle Detection for Road Traffic Vehicle Detection for Road Traffic MeasurementMeasurement

54 St.

53 St.

52 St.

51 St.

EwingAve.

DrewAve.

ChowenAve.

BeardAve.

vehicle

7 DIWANS'06

Related WorkRelated Work

1. Temporally and Spatially Partial Coverage① The region under surveillance is covered partially in

terms of time and space.

② Our scheduling algorithm utilizes this partial coverage to save sensing energy.

2. Quality of Surveillance (QoSv)① Our QoSv is defined as the reciprocal of the average

detection time.

② Other QoSv was originally defined as the reciprocal value of the expected travel distance until the first detection.

8 DIWANS'06

Problem FormulationProblem Formulation

1. Assumptions① The sensors knows their location and are time-synchronized.

② The sensing range is uniform-disk.

③ The cost of turn-off operation is ignorable.

④ The vehicle’s maximum speed is bounded.

2. Objective To maximize the sensor network lifetime to satisfy the

following conditions Provide the reliable detection of every vehicle, Guarantee the desired average detection time, and Facilitate the mobile target tracking after the target detection.

9 DIWANS'06

Sensor Network Model for Sensor Network Model for Road SegmentRoad Segment

Road Segment

Vehicle

S2 S3 Sn. . . . .

Sensing Coverage

10 DIWANS'06

Key Idea to Our SchedulingKey Idea to Our Scheduling

How to have some sleeping time to save energy? We observe that the vehicle needs time l/v to pass the road segment. Time l/v is the sleeping time for all the sensors on the road segment.

Road Segment Length = l

Vehicle

S2 S3 Sn. . . . .

Speed = v

11 DIWANS'06

Energy-Aware Sensor SchedulingEnergy-Aware Sensor Scheduling

1. Our sensor scheduling consists of two phases:① Initialization Phase

② Surveillance Phase Working Period + Sleeping Period

sn ... s2 s1

Time [sec]

Sleeping (I)Initialization

Working (W) Working (W)

. . . . . sn ... s2 s1

Working (W)

Sleeping (I)

12 DIWANS'06

Sensing Sequence for Sensing Sequence for Vehicle DetectionVehicle Detection

S1 . . . . .(b)

Sensor Scheduling Sequnce

S2 S3 S4 SnSn-1Sn-2

S1 . . . . .(c) S2 S3 S4 SnSn-1Sn-2

S1 . . . . .(d) S2 S3 S4 SnSn-1Sn-2

S1 . . . . .(e) S2 S3 S4 SnSn-1Sn-2

S1 . . . . .(f) S2 S3 S4 SnSn-1Sn-2

Detected

S1Vehicle . . . . .(a)

All sensors are sleeping

S2 S3 S4 SnSn-1Sn-2

13 DIWANS'06

Optimality of Sensor SchedulingOptimality of Sensor Scheduling

1. Sensor Network Lifetime

The following energy can be saved through sleeping:

Number of Surveillance Periods

Working Period

Sleeping Period

14 DIWANS'06

Considerations on Turn-On and Considerations on Turn-On and Warming-UP OverheadsWarming-UP Overheads

1. Each Sensor’s Lifetime without Sleeping

2. Sensor Network Lifetime through Sleeping

Case 1: Turn-On Overhead is greater than Sleeping benefit

Case 2: Turn-On Overhead is less than

Sleeping benefit

15 DIWANS'06

QoSv-Guaranteed Sensor SchedulingQoSv-Guaranteed Sensor Scheduling

1. Average Detection Time for Constant Vehicle Speed

Approximate Average Detection Time (ADT)

2. Average Detection Time for Bounded Vehicle Speed

16 DIWANS'06

Determination of Scheduling Determination of Scheduling ParametersParameters

1. Scheduling Parameters are① The sensor network length (l)

② The working time (w)

③ The sleeping time (s)

2. Sensor Network Length (l)

3. Working Time (w)

4. Sleeping Time (s)where

Sensor Network Length

Vehicle

S2 S3 Sn. . . . .

17 DIWANS'06

Sensor Scheduling for Complex Roads Sensor Scheduling for Complex Roads (1/4)(1/4)

Road Network between the Inner and Outer Boundaries

Outer Boundary Inner Boundary

Vehicle

Network

18 DIWANS'06

Sensor Scheduling for Complex Roads Sensor Scheduling for Complex Roads (2/4)(2/4)

A Connected Graph for an Exemplary Road Network The Road Network is represented as a Connected Graph

between the Inner and Outer Boundaries.

19 DIWANS'06

Sensor Scheduling for Complex Roads Sensor Scheduling for Complex Roads (3/4)(3/4) Construction of Scheduling Plan in Road Network

Determine the starting points Si to satisfy the required QoSv through Search Algorithm.

20 DIWANS'06

Sensor Scheduling for Complex Roads Sensor Scheduling for Complex Roads (4/4)(4/4) Scanning in Road Network

One scanning can be split into multiple scanning. Multiple scanning can be merged into one scanning for

sensing energy.

split merge

21 DIWANS'06

Performance EvaluationPerformance Evaluation

1. Metrics① Sensor Network Lifetime according to Working Time and

Turn-on Energy

② Average Detection Time according to Working Time and Road Segment Length (i.e., Sensor Network Length)

③ Required Average Scanning Number for Sensing Error Probability

2. Validation of Numerical Analysis① We validated our numerical analysis of our scheduling

algorithm through simulation.

22 DIWANS'06

Sensor Network LifetimeSensor Network Lifetime according to according to Working Time and Turn-on EnergyWorking Time and Turn-on Energy

23 DIWANS'06

Average Detection TimeAverage Detection Time according to according to Working Time and Road Segment LengthWorking Time and Road Segment Length

24 DIWANS'06

Required Average Scanning NumberRequired Average Scanning Number for for Sensing Error ProbabilitySensing Error Probability

25 DIWANS'06

ConclusionConclusion

1. We proposed an Energy-Aware Scheduling Algorithm to satisfy the required QoSv in Linear Sensor Network. QoSv is defined as the reciprocal value of

Average Detection Time (ADT).

2. Our Algorithm can be used for ① Surveillance for City’s Border Roads, and

② Traffic Signal Control in Crossroads.

3. Future Work We develop the specific algorithm for traffic signal

control in the transportation system.

26 DIWANS'06

Q & AQ & A

Energy-Aware Scheduling with Quality of Surveillance Guarantee in Wireless Sensor Networks

Documents