Post on 17-Feb-2016
description
transcript
Structural Design Institute
CSI ETABS2013 – Session 2
Structural Design Institute
Go to “File”
From the dropdown list select “New Model”
Use Built in setting as shown below
Structural Design Institute
From the “New Model Quick Template” select “Blank”
and click “OK”
Structural Design Institute
Go to “Options”
From the dropdown list select “Graphic Colors” and
“Display”
Set Screen “Black”
Structural Design Institute
Check “Units”
Go to “Edit”
From the dropdown list select “Edit Stories and Grid Systems”
Click “Modify/Show Grid Systems”
Structural Design Institute
Define Grid as shown below
Structural Design Institute
Define Grid as shown below
Structural Design Institute
Same way, Define Stories as shown below
Structural Design Institute
Same way, Define Stories as shown below
Structural Design Institute
Go to “Define”
From the dropdown list select “Material Properties”
Add new material
Structural Design Institute
Go to “Define”
From the dropdown list select “Frame Sections”
Add new Column size “C800x800”
Add new Beam size “B800x300” ,“B600x300” and “B1000x300”
Structural Design Institute
Go to “Define”
From the dropdown list select “Slab Sections”
Add new Slab size “S150” and “S500”
Structural Design Institute
Go to “Define”
From the dropdown list select “Wall Sections”
Add new Wall size “W200” and “W250”
Structural Design Institute
“Set Plan View” to Basement
Start Model
Remember the pattern, Bottom to Top and Left to Right
Structural Design Institute
“Set Plan View” to Basement
Define Loads, Combinations and Assign Loads
Structural Design Institute
Set “Floor Auto Mesh” option to “No Auto Meshing”
Structural Design Institute
Manually Mesh the model
Structural Design Institute
“Set Plan View” to Ground
Start Model
Structural Design Institute
“Set Plan View” L1
Start Model
Structural Design Institute
Replicate Stories
Save Model
Structural Design Institute
Run the Model and See Results
Check Mode Shapes
Column Axial Forces
Bending Moments
Deflections
Wall Stresses S22