Ethernet ip r0

transcript

MCA 121 Ethernet / IP Option

Checking module

Checking MCA 121 Ethernet / IP Option

AutomationDriveVLT

Line:Line:

AutomationDriveVLT

Star:Star:

Build-in 2-port switch Build-in 2-port switch makes it possible to makes it possible to connect the drives in a connect the drives in a traditional line-topology.traditional line-topology.

Master access all parameter of drive using Explicit Master access all parameter of drive using Explicit Messaging.Messaging.Using EDS, Master can access CTW, STW and PCD’s.Using EDS, Master can access CTW, STW and PCD’s.

Network addressing can be Manual or Network addressing can be Manual or AutomaticAutomatic

Installing MCA 121

MCA 121 uses slot A and BMCA 121 uses slot A and B

A + B in C Adaptor in under A + B in C Adaptor in under constructionconstruction

Minimum hardware to test MCA121

PC and drive have to be PC and drive have to be set to manual set to manual addressingaddressing

Switch

PC running a browser

Switch Switch doesn’t have doesn’t have to be setto be set

Setting IP address on PC

Manual Addressi

Automatic

Addressing

Setting IP address on drive

Manual AddressingAutomatic Addressing

After setting the drive, it is necessary to cycle the power.After setting the drive, it is necessary to cycle the power.

Using browser to access MCA 121

Use address reading from

P12-01

192.168.000.010

pump_1@build.com

maintenance@build.com

Ethernet ip r0

Engineering