Ethernet over MPLS tests - TERENA • communicate • collaborate Ethernet over MPLS Layer 2...

Post on 09-Mar-2018

229 views 3 download

transcript

connect • communicate • collaborate

Ethernet over MPLS tests

Marcin Garstka, Poznań Supercomputing and Networking Centre

Copenhagen, 20 November 2012

The research leading to these results has received funding from the European Community’s Seventh Framework Programme (FP7/2007-2013) under grant agreement no 238875 (GÉANT)

connect • communicate • collaborate

Agenda

Summary of the technologyTechnology testing:

OAMProtection and RestorationMultidomainMulticastEoMPLS services over MPLS-TP

2

connect • communicate • collaborate

Ethernet over MPLS

Layer 2 transport over an IP/MPLS networkMultiple Layer 2 technologies, Ethernet dominating nowedaysPoint-2-Point (VPWS, Layer 2 VPN) and Multipoint-2-Multipoint (VPLS) servicesLayer 2 multicast using point-to-multipoint LSPs as an emergingservice

3

connect • communicate • collaborate

Data Plane

IP/MPLS networkPseudowire transportRSVP or LDP to establish Label Switched PathsRSVP has traffic engineering functions and Fast RerouteLayer 2 functions (e.g. MAC learning) for VPLS only on edge routersBackbone routers not aware of the services

4

connect • communicate • collaborate

Control Plane

2 protocols:BGP (with neighbour autodiscovery)LDP (simpler but without autodiscovery)

5

connect • communicate • collaborate

Tests on Juniper routers

The purpose of the tests was to assess the status of implementation of selected VPWS and VPLS features on commercially available routers. The selected features are either new or interesting for research and education networks.The ultimate goal of the tests was to verify if the Ethernet over MPLS technology fulfills selected requirements for Carrier Class Transport Network Technologies identified in [GN3-09-224_DJ1.1.1].Tests executed on Juniper Networks routers.Juniper MX-series routers (MX-240, MX-480 and MX-960), software 11.1R2.3.

6

connect • communicate • collaborate7

Ethernet OAM tests

connect • communicate • collaborate

802.1ag Connectivity Fault Management and MPLS trace test

8

Continuity CheckProtocolLinktrace ProtocolMPLS Trace

No MIPs or MEPs possible on transit routersContinuity Check Protocol was able to indicate loss and restorationof connectivityLinktrace was able to trace the connection but not able to locate the outageMPLS Trace was able to trace the path but not able to locate the outageMAC Ping also tested with positive results

connect • communicate • collaborate

Y.1731 Ethernet frame delay measurement test

9

One-way and Two-way frame delay and frame delay variationmeasured in the Customer DomainNot supported in the Provider Domain on the routers used for tests

connect • communicate • collaborate

Y.1731 ETH-AIS test

10

Not supported by Juniper

connect • communicate • collaborate11

Protection and Restoration tests

connect • communicate • collaborate

MPLS Fast Reroute in VPWS and VPLS test

12

Without Fast Reroute

With Fast Reroute

Recovery time [ms]

Recovery time [ms]

BGP-signaled VPWS 190 21LDP-signaled VPWS 187 22BGP-signaled VPLS 334 25LDP-signaled VPLS 346 22

RSVP with Fast Reroute (Link Protection)

connect • communicate • collaborate

BFD and MPLS Fast Reroute test

13

Without BFD With BFDRecovery time Recovery time

BGP-signaled VPWS 21 seconds 72 msLDP-signaled VPWS 26 seconds 72 msBGP-signaled VPLS 20 seconds 76 msLDP-signaled VPLS 25 seconds 70 ms

In bigger networks such short times will not be possible.

BFD for ISIS (minimum interval10, multiplier 2)RSVP with Fast Reroute (Link Protection)

connect • communicate • collaborate14

Multi-domain tests

connect • communicate • collaborate

Multi-domain 802.1ag and MPLS Trace test

15

Labelled unicastInter-AS option C – eBGPbetween Route Reflectors (not ASBRs) for VPN routesredistributionCointinuity Check Protocol and Linktrace protocol properlyindicated loss of connectivity in the Provider DomainThe protocols cannot be used in the Operator Domain (single AS)MPLS trace not supported for inter-AS option C

connect • communicate • collaborate

Multi-domain restoration test

16

The LSP was successfully rerouted to link P2-P3 when link P1-PE2 was disconnected.The time needed for service restoration was 31 ms.

connect • communicate • collaborate17

Multicast in VPLS tests

connect • communicate • collaborate

Multicast in VPLS tests

18

Efficient multicast replication with P-to-MP LSPsThe same router can serve as transit and accessService restoration tested whenone of the links was disconnected

connect • communicate • collaborate19

VPWS and VPLS over MPLS/TP tests

connect • communicate • collaborate

Multicast in VPLS tests

20

EoMPLS services demonstratedover LSPs provisioned by ASPEN Network Manager

connect • communicate • collaborate

Summary

21

Ethernet over MPLS proved to be a technology carriers and NRENs shouldconsider for their networks

OAMFast recoveryMultidomain operationsL2 multicast

connect • communicate • collaborate22

Thank you very much

Questions ?