Post on 28-Mar-2016
description
transcript
FabChair
Fab Design
FabChair
Barcelona 2010
Materials:
Machine:
Designer: Tomas Diez
Wood 20 mm, 833x406mm - 1 piece. 1/3 of a standard plywood sheetSOFTWARE– Rhinoceros (Modeling) Partworks 3 (Dogbones)SET- 4 nuts and 4 screws (The ones that come with shopbot)
TECNOLOGY USE -
CNC Milling – Shopbot PRSalpha 144
CNC Cutting
A
Wood Drillbit 6mm diameter flat end.Set Shopbot and spindle speed as desired
* as long as the machine moves the material doesn’t fly and the bit doesn’t break
B
Cutting process: about 10 min.
C
Remove cut pieces from the wood and placethem on a clean flat surface.
Use this drawing as a reference
1
4
2
2
3
5
3
Assembly:
1.Start by placing the piece in a flat surface, and fit the back and the seat with this piece.
2. Fit the back and the seat with this piece.
3. Fit the crossbars with the same piece.
4. Finally fit the missing piece with the structure and add nuts and screws
together as shown.