Post on 29-Jul-2018
transcript
*The “TEMP-SURE” requires a separate 208-230v 3 phase 40amp power supply.
Is your Low Temp dishmachine lacking an adequatesupply of hot water to assure proper sanitation istaking place in the dishroom? We have the answer -“CMA TEMP-SURE”. Rather than replace your existingwater heater with something larger and moreexpensive, add the “TEMP-SURE” booster heater toyour machine. The “TEMP-SURE” is mounted to theside of dishmachine, not requiring any of your valuable kitchen space. The “TEMP-SURE” providesan additional 40 degrees of temperature rise to yourincoming dishmachine water supply, which will helpprevent your existing water supply source frombeing over burdened. Have “PEACE OF MIND” thatproper dishware sanitation is taking place and preventing health risks. (Available on most CMA dishmachines).
The cost to add the “TEMP-SURE” built in at the factory is only $2,098.00 (list price) and it can be purchased separately with a field kit for field installation for $2,184.00 (list price).
DISHMACHINES
12700 KNOTT STREETGARDEN GROVE, CALIF. 92841800-854-6417•714-898-8781•FAX 714-895-2141www.cmadishmachines.com
ULR
LISTEDCOMMERCIALDISHWASHER
864T
Model B (Double)Also Available as Corner B
Features A Hot Water Booster Option for Peace of MindFeatures A Hot Water Booster Option for Peace of Mind
FEATURING CMA TEMP-SUREBOOSTER HEATERS
FEATURING CMA TEMP-SUREBOOSTER HEATERS
Model E-AHAlso Available as E-Corner
Booster Heater
Booster Heater
Booster Heater
Model E-AHAlso Available as EST-Corner
7-2014
Hot Water Booster Heater
Hot WaterBooster Heater
CMA®
Registered Trademark
MIZER
TEMP-SURE FLYER 3-18-2014_Layout 1 7/8/14 11:52 AM Page 1
The CMA-Temp-SureTM option assures a continuoussupply of 140°F hot water resulting in excellentd i s h m a c h i n e p e r f o r m a n c e . T h e h e a t e r i scustom-designed for fill and dump CMA single tankdishwashers as a factory added option or an infieldadd-on. The heater will also fit most competitor’s singletank dishmachines.
FRONT BACK
HEATER ROCKER SWITCH
1/2" MALE PIPE THREADS
HEATER ROCKER SWITCH
7"
834/ "
*INLET
OUTLET
CMA Dishmachines 12700 Knott Street, Garden Grove CA 92841• 800-854-6417 • 714-898-8781 • Fax: 714-895-2141 • www.cmadishmachines.comCMA reserves the right to modify specifications or discontinue models without prior notification.
Printed in the U.S.A. © 7-2014 CMA, Inc.
SPECIFICATIONS:
MODEL: CMA TEMP-SURETM USA METRICMIN. INCOMING WATER TEMP. 100°F (55°C)RISE 40°F (22°C)AVAILABLE HOT WATER 90 GPH (341LPH)HEATER TANK CAPACITY 2.6 GAL (9.8L)ELECTRICAL RATING VOLTS PHASE AMPS
208 1 44240 1 51208 3 26240 3 30
CHANGES FOR 1-PHASE(TIE STRAPS CHANGED AS SHOWN)
ON HEATER
T2
TOPT1
L-2L-2L-1
L-1
* CAUTION: WATER SOLENOID MUST BEPLUMBED AHEAD OF HEATER INLET. HEATERIS NOT A PRESSURE VESSEL.
Hot Water Assurance System For Dump And Fill Style
Dishwashers
CMA TEMP-SURETM
LEFT SIDE RIGHT SIDE
HEATER ROCKER SWITCH
1/2" MALE PIPE THREADS 1/2" MALE PIPE THREADS
5/16" MOUNTING HOLES (4)
1" ELECTRICAL INLET
16/79 "
25"
24"
*INLET
OUTLET
WARNING: Plumbing connections must be made by a qualified service company who will comply with all available Federal, State, and Local Health,Plumbing and Safety codes.
L-3
L-2
L-1
T-3
3
28
T-2
T-1
THERMOSTAT
HIGH LIMITSWITCH
ROCKERSWITCH
REDRED
BLUE
RED
Power Supply: Hook Up Wire With Highest Voltage On L-2.
GROUND
TOP
3 PHASE WIRE SCHEMATIC
L-1
L-3L-2
DISHMACHINES
CMA
®
Registered Trademark
ULR
LISTEDCOMMERCIALDISHWASHER
864T
USC
Temp-Sure Sheet Back 7-2014_Temp-Sure Sheet Back 7/8/14 11:51 AM Page 1