Post on 14-Jan-2016
transcript
GEO3020/4020
Evapotranspiration
• Definition and Controlling factors• Measurements• Physics of evaporation• Estimation of free water evaporation, potential and actual evapotransp.• Processes and estimation methods for bare soil, transpiration,
interception
I. Meteorological Elements
II. Energy Balance
III. Evapotranspiration
2
is determined by the energy and mass transport at the surface:
Weather
Meteorological variables are used to describe the weather and to calculate the components of the energy and water balance equation.
Energy transportLE: 15%H: 60%Oceans: 25%
• Precipitation• Radiation• Air temperature• Air humidity• Wind• Air pressure
3
Meteorological variables
4
Radiation
Why do we want to calculate the radiation budget at the land surface?
5
30% 70%
6
Summary
= Extraterrestrial Radiation on a horizontal plane
= Extraterrestrial Radiation on a sloping plane
= Total daily clear sky incident radiation on a horizontal
plane at the earth surface
= global short wave radiation at the earth surface
= backscattered radiation (= )
and
'ETK
ETK
'csK
'gK
''''' 5.0 ETETsdirdifg KKKKK
'bsK
'''bsgsc KKK
'5.0 gs K
7
• Structure of the atmosphere• Composition• Vertical structure
• Pressure-temperature relation (Ideal gas law)• Adiabatic lapse rate (dry & wet)
• Vapour – Vapour pressure, ea
– Sat. vapour pressure, ea*– Absolute humidity, ρv – Specific humidity, q = ρa/ρv – Relative humidity, Wa = ea/ea*– Dew point temperature, Td
GEO3020/4020
Lecture 2: I. Energy balance II. Evapotranspiration
Energy balance equation
9
0/ tQAGLEHLK w
where:
K net shortwave radiationL net longwave radiationLE latent heat transferH sensible heat transferG soil fluxAw advective energyΔQ/Δt change in stored energy
Units: [EL-2T-1]
Bowen ratio = H/LE replace H = B∙LE
10
Controlling factors of evaporation
I. Meteorological situation• Energy availability• How much water vapour can be received
– Temperature– Vapour pressure deficit– Wind speed and turbulence
11
Controlling factors of evaporationII. Physiographic and plant characteristics• Characteristics that influence available energy
– albedo– heat capacity
• How easily can water be evaporated– size of the evaporating surface– surroundings– roughness (aerodynamic resistance)– salt content– stomata
• Water supply– free water surface (lake, ponds or intercepted water)– soil evaporation– transpiration
The wind speed immediately above the surface. • The humidity gradient away from the surface.
– The rate and quantity of water vapor entering into the atmosphere both become higher in drier air.
• Water availability. – Evapotranspiration cannot occur if water is not available.
EvapotranspirationMeasurements
Free water evaporation- Pans and tanks- Evaporimeters
Evapotranspiration (includes vegetation)- Lysimeters- Remote sensing
12
GEO3020/4020
Lecture 3: Free water Evaporation
Flux of water molecules over a surface
14
15
Zveg
Zd
Z0
velocity
22)-(D ln1
0*
z
zzu
kv dm
m
Momentum, sensible heat and water vapour (latent heat) transfer by turbulence (z-direction)
16
Steps in the derivation of LE• Fick’s law of diffusion for matter (transport due to differences in the concentration of water vapour);• Combined with the equation for vertical transport of water vapour due to turbulence (Fick’s law of
diffusion for momentum), gives:
DWV/DM (and DH/DM) = 1 under neutral atmospheric conditions
17
42)-(D )e-(e
ln
622.0ms2
0
2
zzz
vk
PD
DLE
da
maV
M
WV
18
Latent heat, LE
Latent heat exchange by turbulent transfer, LE
where
where
a = density of air;
λv = latent heat of vaporization;
P = atmospheric pressure
k = 0.4;
zd = zero plane displacement
height
45)-(D asaLE eevKLE
43)-(D
ln
622.02
0
2
zzz
k
PK
da
aVLE
z0 = surface-roughness height;
za = height above ground surface
at which va & ea are measured;
va = windspeed,
ea = air vapor pressure
es = surface vapor pressure (measured at z0 + zd)
19
Sensible heat, H
Sensible-heat exchange by turbulent transfer, H (derived based on the diffusion equation for energy and momentum):
where
where
a = density of air;
Ca = heat capacity of air;
k = 0.4;
zd = zero plane displacement
height
52)-(D asaH TTvKH
50)-(D
ln
2
0
2
z
zz
kcK
da
aaH
z0 = surface-roughness height;
za = height above ground surface
at which va & Ta are measured;
va = windspeed,
Ta = air temperatures and
Ts = surface temperatures.
Selection of estimation method
• Type of surface• Availability of water• Stored-energy• Water-advected energy
Additional elements to consider:1) Purpose of study
2) Available data
3) Time period of interest
20
21
Estimation of free water evaporation
• Water balance method• Mass-transfer methods
• Energy balance method• Combination (energy +
mass balance) method• Pan evaporation method
Defined by not accounting for stored energy
22
Mass-transfer methodPhysical based equation:
or
Empirical equation:
- Different versions and expressions exist for KE and the empirical constants b0 and b1; mainly depending on wind, va and actual vapour pressure, ea
saaE eevKE saaLE eevKLE
(1802)Dalton ref. )( 10 saa eevbbE
23
Calculation of evaporation using energy balance methodSubstitute the different terms into the following equation, the evaporation can
be calculated
where
22)-(7 /
vw
w tQAHGLKE
15)-(7 / tQAHGLKLE w
Latent Heat of Vaporization :v= 2.495 - (2.36 × 10-3) Ta
[MJkg-1] or 2495 J/g at 0oC
LE has units [EL-2T-1]
E [LT-1] = LE/ρwλv
24
Penman combination methodPenman (1948) combined the mass-transfer and energy balance approaches to get an equation that did not require surface temp.:
I. Simplifies the original energy balance equation:
thus neglecting ground-heat conduction G, water-advected energy Aw, and change in energy storage Q/t.
II. The sensible-heat transfer flux, H, is given by:
I. + II. gives the Penman equation:
1)-(7B1 vw
HLKE
2)-(7B1 asaH TTvKH
33)-(7
)(
1)( *
vw
aaavwE WevKLKE
Penman equation – input data
• Net radiation (K+L)
(measured or alternative cloudiness, C or sunshine hours, n/N can be used);
• Temperature, Ta (gives ea*)
• Humidity, e.g. relative humidity, Wa = ea/ea*
(gives ea and thus the saturation deficit, (ea* - ea)
• Wind velocity, va
Measurements are only taken at one height interval and data are available at standard weather stations
25
GEO3020/4020
Lecture 4: Evapotranspiration- bare soil- transpiration - interception
Lena M. Tallaksen
Chapter 7.4 – 7.8; Dingman
Influence of Vegetation
• Albedo• Roughness• Stomata• Root system• LAI • GAI
27
Aerodynamic and surface resistance
Modelling transpiration
28
Rearrange to give:
)e-(e
ln
622.0ms2
0
2
zzz
vk
PD
DLE
dm
maV
M
WV
)e-(e
and
)e-(e
ln
622.0
as
as2
0
2
C KE
v
z
zz
k
D
D
P
LEE
atat
m
daM
WV
w
a
wV
Atmospheric conductance, Cat
29
ln25.6
2
0
zzz
vC
dm
mat
Orignal Penman
Penman (physical based wind function)
Penman (atmospheric conductance)
Penman equation – 3 versions
30
)(
1)( *
vw
aaavwE WevKLKE
)(
1)( *
vw
aaataa WeCcLKE
)(
1)()( *
vw
aa WeufLKE
Penman-Monteith
Penman
Penman-Monteith
31
55)-(7
)(
1)( *
vw
aaataa WeCcLKE
where
56)-(7 1
1)( *
CLAIfC
CC
WeCcLKE
leafscan
can
atvw
aaataa
”Big leaf” concept
Interception: Measuring and Modelling
32
Function of:
i)Vegetation type and age (LAI)
ii)Precipitation intensity, frequency, duration and type
Replacement or addition to transpiration?
Estimation of potential evapotranspiration
33
Definition: function of vegetation – reference crop
Operational definitions (PET)
1.Temperature based methods (daily, monthly)Empirical
2.Radiation based methods (daily)Homogeneous, well watered surfaces, e.g. P-T
3. Combination method (daily)Penman or Penman-Monteith (Cleaf: no soil moisture deficit)
4. Pan methods
Estimation of actual evapotranspiration (ET)
• Potential-evapotranspiration approaches– Empirical relationships between P-PET– Monthly water balance– Soil moisture functions– Complementary approach
• Water balance approaches – Lysimeter – Water balance for the soil moisture zone, atmosphere, land
• Turbulent-Transfer/Energy balance approaches– Penman-Monteith– Bowen ratio– Eddy correlation
• Water quality approaches
34
Lena M. Tallaksen
Chapter 9.1-9.2; Dingman
GEO3020/4020
Lecture 10: Rainfall-runoff processes
• Basic aspect of catchment response
– hillslope (and stream network)
• Hydrograph separation
– The Base Flow Index (BFI)
• Linear reservoir model
• Mechanisms producing event response
• (Rainfall-runoff modeling)
36
Streamflow response to precipitation (rain or snow) input
Definition of terms
37
Refer Table 9-1
- Time instants, t- Time durations, T
Hydrograph separation Flow components
Methods for continuous separation similarly divide the total streamflow into one rapid, qef (event flow) and one delayed component, qbf (base flow). The delayed flow component represents the proportion of flow that originates from stored sources (e.g. groundwater).
4,00E+04
4,50E+04
5,00E+04
5,50E+04
6,00E+04
6,50E+04
Rapid response
Base flow
The Base Flow IndexBFI = Vbase flow /Vtotal flow
Isotopic and chemical methods (Box 9.1)
Linear reservoir model of catchment response• Box 9-2
– Catchment response time, T*– Influence of storm size and timing– Influence of drainage basin characteristics
• Summary of their influence is given in Table 9.2
39
Mechanisms producing event responseIII. Subsurface flow
I. Channel precipitation
II. Overland flow (surface runoff)
A. Hortonian
B. Saturation excess
III. Subsurface flow
A. Saturated zone1. Local groundwater mounds
2. Perched saturated zones
B. Unsaturated zone1. Matrix (Darcian) flow
2. Macropore flow
40
Questions?
41