Health and Safety in the Laboratory

This material was produced under grant number SH-17035-08-60-F-11 from the Occupational Safety and Health Administration, U.S. Department of Labor. These

materials do not necessarily reflect views or policies of the U.S. Department of Labor, nor does mention of any trade names, commercial products, or

organizations imply endorsement by the U.S. Government.

2

Objectives

After this session, you will know:

• How to identify health and safety hazards of school laboratory work

• Health and safety measures your lab should have in place

• How best to protect yourself from hazardous exposures

• The requirements of OSHA’s Laboratory Standard

3

Laboratories in the News

Two dozen fire departments responded yesterday to Rocky Point High School after a science teacher was burned when a chemical reaction in a science lab touched off a small explosion. The teacher, Anthony Nobre, 26, of Medford, suffered burns over his arm, neck and face. He was taken to University Hospital in Stony Brook, where he was listed in satisfactory condition, according to a spokeswoman. The blast erupted as Nobre put crystallized sodium into a container holding a small amount of water. The Brookhaven fire marshal was conducting an investigation and recommended that the building be closed today.

Detroit’s Miller Middle School will be closed today and possibly Wednesday while health and environmental officials finish cleaning up a small amount of mercury that students spilled in a science class just before school was dismissed Monday. Students apparently were playing with about an ounce of the toxic substance in a sealed vial when it spilled, said a district spokesman Stan Childress. About 30 students and a teacher were present, he said. There is a possibility that students may have tracked through the mercury because some beads of the substance were found in the hallway, Childress said.

4

Why All the Fuss?

Exposure to Hazardous Chemicals Can Result in acute or chronic health effects

Acute – occurring within hours or days of exposure

Chronic – occur after exposure over many years

5

Engineering: Removes or Separates Hazard from Person i.e.:

• Local Ventilation (Fume Hoods)

• Chemical Substitutions

Administrative:

Procedures that Limit

Contact with Hazard i.e.:

• Job Rotation

• School Staff Training

• Good Housekeeping

6

Personal Protective Equipment (PPE)

PPE Should Be Considered Only

After Administrative and

Engineering Controls Have Been

Applied.

Minimum Recommended PPE:

Chemical Resistant Gloves, Splash Proof Goggles,

Lab Coat, Face Shield, and Rubber Apron when Necessary

7

PPE: Glove Selection

Should be based upon:

• the chemical composition of the substance you are working with

• the properties of the glove material.

Find Out More about Glove Selection by

Reviewing Material Safety Data Sheets (MSDS) or

from Glove Supply Companies.

8

OSHA’s Laboratory Standard

• Protects staff who use and handle hazardous chemicals in laboratories

• Requires your School to:

– Determine staff exposure to any substances regulated by the standard

– Conduct initial training & additional training if a new hazard is introduced into the lab

– Develop a Chemical Hygiene Plan

9

Training Requirements

Labs are required to supplement course material with site-specific information & training including:

•Specific Work Practices

•Chemical hygiene plan/lab manual

•Location & availability of MSDSs

•Specific lab safety work practices or SOPs

•Training whenever new hazards are used in the lab

•Personal Protective Equipment

•Instruction on appropriate PPE & how to use it

•Location & availability of PPE & maintenance of reusable PPE

•Lab Equipment

•Location & operation of eyewash &/or shower stations

•Use of fume hoods, storage cabinets, refrigerators & other engineering controls

•Waste Handling and Spill Response

•Chemical waste handling & disposal procedures

•Location & availability of spill kits & emergency checklists

•Spill response procedures

10

Chemical Hygiene Plan

• Must Include: • Designation of a Chemical Hygiene Officer

• Exposure control measures

• Measures to ensure properly functioning fume hoods & equipment

• Staff training on hazard awareness & measures available to protect themselves

• Provisions for medical consultation & examination

• Respiratory protection program

• Recordkeeping procedure

• Hazard identification system

11

Safe Practice: Maintain a Chemical Inventory!

Conduct a yearly inventory of chemicals and

update the file of material safety data sheets

(MSDS) to prevent the accumulation of orphaned

chemicals

Some of these chemicals become

unstable, react with the container, slowly

degrade or evaporate

12

You Have the Right to Know!

OSHA’s Hazard Communication

Standard requires that

ALL Containers Must be Labeled With:

Chemical

Name &

Physical/

Health

Hazards

Name &

Address of

the

Manufacturer

& Emergency

Contact

Numbers

100 Main St., Philadelphia, PA

1-800-555-1212

13

Types of Labels

NFPA Diamonds and

HMIS Bars are Color &

Number Coded with

Hazard Information

DOT Symbols Are

Usually Found on

Shipping Cartons

14

Material Safety Data Sheets (MSDS) • An MSDS Must Be on File & Available for

Each Chemical in the Lab.

• An MSDS lists: – Product Identity

– Hazardous Ingredients

– Physical Data

– Fire & Explosion Hazard Data

– Reactivity Data

– Health Hazard Data

– Precautions for Safe Handling & Use

– Control Measures

15

What Should the Ideal Laboratory Look Like?

• Practices • Equipment & Ventilation

16

Supply Air Diffusers & Room Air Exhausts

Should be

Located So As to Avoid Intake of

Contaminated Air

Windows Should be Operable

General Ventilation

17

Local Ventilation

Fume Hoods Used For Operations that Give Off:

• Noxious Odors

• Flammable or Poisonous Vapors

HOW DOES YOUR VENTILATION MEASURE UP?

18

Safety Showers and Eyewashes

Must Be Available in All Lab Areas

That Use or Store Chemicals Which

Are Corrosive or an Irritant to the

Eyes or Skin

Combination Eye Wash & Drench

Hose Units at the Sink are Now

Available

19

Match the Extinguisher to the Risk!

Fire Extinguishers Must Be:

Clearly labeled to indicate the types of fire they are designed to extinguish.

Visibly inspected monthly and maintained annually.

Class ABC Extinguishers Should Be

Located:

–At the Laboratory Exit

–Within 50 Feet of Any Point

in the Lab.

Class D Extinguishers Are Required

for Combustible Metals.

20

Means of Egress/Exit

Two or more well- marked

& unobstructed evacuation

exits are recommended in

a lab.

21

It’s Shocking!

There should be no accessible live, exposed electrical

wiring.

Consideration should be given to installing ground-fault circuit interrupters on electrical circuits within

6 feet of water sources.

Electrical Safety in the High School Lab

22

Chemical Storage

Safe Storage of Chemicals is a Necessity in Every School Laboratory!

Minimizes Exposure to Students and Staff to Corrosive and Toxic Chemicals

Lessens the Risk of Fire

Prevents the Mixing of Incompatibles & the Creation of an Emergency Situation

23

The “Don’ts” of Chemical Storage!

Avoid storing any chemical above eye level

Don’t store incompatible chemicals together

Don’t store chemicals near sources of heat or sunlight

Don’t store chemicals in the hoods or acids on metal shelves

Avoid storing anything on the floor, especially glass bottles

24

Biology Storage

25

So, You’re in Charge!

• How would you organize and store chemicals in your perfect lab?

26

Ideal Storage Area Set-

Up

Acids NA, LI

Oxidizers

Bases

Flammables

Cabinet

Metal Salts

Nitrates

Spill

Materials

Room Should Have:

•Eye Wash

•Safety Shower

•Emergency Phone

•Fire Extinguisher

Dry

Chemicals

27

– Organic Solvents

– Acids

– Alkalis (Bases)

– Mercury

Be Prepared for Small Incidental Spills

Proper Incidental Spill Control Equipment Includes:

Spill Control Materials Such As Spill Control Pillows, Pads, Booms, etc.

Scoops, Brooms, Pails & Bags

Absorbent – such as Diatomaceous Earth

Neutralizers – for Acids & Alkalis

Mercury Spill Control Kit

Chemical Categories

Found in Most Secondary

Schools Include:

28

Certain Spills Aren’t for Quick Clean-up

• As a science teacher or lab specialist, you should only respond to incidental chemical releases, or small spills.

• For large or especially hazardous spills: – Quickly assess whether there are any

injured persons and attend to any person who may have been contaminated.

– Follow the notification, evacuation and emergency medical treatment procedures for your school.

– Evacuate the immediate area until the hazardous release has been characterized and controlled.

29

Waste Chemical Disposal

• Requires:

– Proper storage– same rules apply – make sure waste chemicals are compatible

– Proper labeling – tags should be placed on bottles name of chemical

– Pre-planning – know what waste you’re creating prior to carrying out experiments; minimize purchases

– Record-keeping – of all waste chemicals on hand and those already picked up for disposal

30

How to Assess Your Classroom for Hazards

• Using the Checklist

• Working with Your Union