High Intensity, Water-Cooled Lighting for Modern Farmerswww.coolbar.co

REPLACING A LIGHT BOARD

This is the fitting on the end of the bar that connects it to the water/coolant pipes. It might take a bit of wiggling since there is plumber’s glue to keep it from leaking.

STEP 1: TAKE OFF THE PIPE FITTING

There are four screws holding the end cap in place. Take them out and remove the end cap.

STEP 2: REMOVE THE SCREWS ON THE END WITH A SCREW DRIVER

Press down on one side of the shroud until it starts to pop out of the groove. Then take the edge of the shroud and run your fingers or a screw driver under it until the whole shroud has popped off the CoolBar.

STEP 3: POP OFF THE PLASTIC SHROUD

There are seven small screws in the light board to keep it in place. STEP 4: UNSCREW SCREWS ON THE LIGHT BOARD

The light board is connected to adjacent light boards with 2 pins on either end. These should wiggle free quite easily with a bit of a tug.

STEP 5: TUG OUT THE LIGHT BOARD

Pop the new light board in and replace screws, end cap, and pipe fitting. (In other words, put everything back the way it was.)

STEP 6: POP THE NEW LIGHT BOARD IN

Get that CoolBar back to lighting your crops!

LEARN MORE ABOUT SUPPLYING GREAT LIGHT TO YOUR CROPS

LEARN MORE

Have questions? Feel free to give us a call at (307) 288-1188.