How To Tie a Tie?

•Half Windsor Knot•Windsor Knot •Pratt Knot

Common Methods Of Tying A Tie

Step 1

Start with the wide end ("W") of your necktie on the right, extending about 30cm below the narrow end ("N") on the

left.Step 2

Cross the wide end over the narrow end.

Windsor Knot

Step 3

Turn the wide end back underneath the narrow end.

Step 4

Continue by bringing the wide end back over in front

of the narrow end again.

Step 5

Then, pull the wide end up and through the loop

around your neck.

Step 6

Hold the front of the knot loosely with your index

finger and bring the wide end down through the front

loop.

Step 7

At last, remove your finger and tighten the knot

carefully to the collar by holding the narrow end and

sliding the knot up.

Instructional Videos on How To Tie A Windsor Knot

Checking The Neatness Of Your Tie

•Look in the mirror as you adjust your tie.

•Adjust the ends of the tie. Make sure the wide end of the tie is longer than the narrow end.

• The knot should be centered directly in the middle of your collar.

•Make sure length of your tie is just above the center of the button on your shorts.

•Pull down the collar of your shirt.

Thank you!