Post on 29-May-2018
transcript
Important Manual Update Please read this before you assemble your EMU-MAX 2014
Your EMU-MAX when shipped comes with the battery disconnected The following instructions will explain how to re-‐connect the battery.
EMUMAXBATT111114.1
1/ Undo the four silver screws that hold the battery cover, two on the back and one each side of the battery cover with the Phillips screwdriver provided in your tool bag. 2/ Gently lift the white cover upwards exposing the battery compartment. Ensure that the four metal screw tabs remain in place.
3/ Down in the battery compartment at the back you will find a black wire with a three-‐pin plug on the end. Gently pull the cable to reveal the plug. 6/ This plug needs to be connected to the connector on the back of the battery. The connecter is protected underneath the black cloth cover on the back of the battery. 7/ Carefully push the plug securely into the connector. 8/ R-‐fit the battery cover following steps 4/3/2/1 10/ Switch on the key and the green lights should illuminate on the light pod indicating you have power. Note you may hear a chirp when you connect the battery.