Post on 06-Aug-2020
transcript
Orient 1 set-up
Assemble the hybrid pole. 1 Raise pole by opening latch. Secure
Secure pole in the base of stand. 2 at desired height. 3 Gently raise graphic.
Graphic to top rail attachment
x2
+-01 • ~ -:\- -
'Gently lean the unit back, pulling the graphic up by the toprail and secure Pull out plastic end caps, unsnap top Attach graphic to top rail slider and
onto top pole. 5 Leveling feet located under unit. 6 rail and remove slider from rail. 1 insert top rail slider back into the rail. 2
Graphic to base attachment
Line the bottom of the front of the graphic print with adhesive tape
on white leader strip. 1
Once aligned pull adhesive tape Snap close top rail and insert the slowly while applying pressure to Place additional masking tape for
end caps. 3 graphic to adhere tape. 2 extra protection. 3
4
;~,_,
Remove pin while holding onto the graphic so the graphic does not Slowly retract the graphic back
retract back in quickly. 4 into the base. 5