Post on 20-Jun-2015
description
transcript
Hyundai i30 Navigation System Installation
Data collected by www.autocardvdgps.com
Dismantle step
1. Original factory stock radio system
2. Use plastic knife to loosen the panel
Powered by www.autocardvdgps.com
3. The panel had been loosen.
4. Loosen two sides of the panel and pay attention to the buckling position
Powered by www.autocardvdgps.com
5. Unplug the harness from the back
6. You can see the CD player after taking out the harness of the frame.
Powered by www.autocardvdgps.com
7. Remove the screws around original radio system
8.Take out the original radio system as follows:
Powered by www.autocardvdgps.com
8. Unplug the harness from the back of the original stock radio system
10. It is done.
Powered by www.autocardvdgps.com
Installation Steps
1. Before installing our head unit
2. Remove the original brackets and install them to our head unit on the two sides The picture shows left bracket
Powered by www.autocardvdgps.com
3. The picture shows right bracket
4. After installing the brackets.
Powered by www.autocardvdgps.com
5. Wire GPS antenna through the dashboard, make sure there is a good signal receipt of the GPS antenna
6. Plug the harness of the speaker
Powered by www.autocardvdgps.com
7. Plug ISO cable
8. All the connectors are ready
Powered by www.autocardvdgps.com
9. All the harness must get through the iron sheet from rear of the car, there is no room to install it .
otherwise ,
10. Here are all the harnesses which get through from the iron sheet of the car
Powered by www.autocardvdgps.com
11. Plug ISO cable connector at the back of this unit
12. Plug the connector of the speaker
Powered by www.autocardvdgps.com
13. Plug the power connector
14. Make sure ISO cable, speaker and power connectors had been plugged properly.
Powered by www.autocardvdgps.com
15. Plug GPS antenna
16. Plug radio antenna
Powered by www.autocardvdgps.com
17. Plug USB connectors
18. All the cables had been connected.
Powered by www.autocardvdgps.com
19. Install our head unit to your car
20. Fasten all the screws
Powered by www.autocardvdgps.com
21. Attach original left & right a/c vent to our frame (provided with head unit)
22. After installing on the frame
Powered by www.autocardvdgps.com
23. Connect air conditioning cables
24. connect the cables as follows:
Powered by www.autocardvdgps.com
25. Make sure air conditioning connectors had been plugged
26. Install the frame
Powered by www.autocardvdgps.com
27. Done! Installation is completed!
For more information, please visit www.autocardvdgps.com
Powered by www.autocardvdgps.com