Post on 17-Jan-2016
transcript
ISX12 G & ISL G
Cold Weather Operation
1
2
ISX12 G and ISL G Cold Weather Operation
Cold weather affects CEGR SI natural gas engines differently compared to CEGR CI diesel engines
Natural gas engines are susceptible to sub-freezing intake air
Too cold intake air forms condensation in charge air coolers and freezes intake components
Measures MUST be taken to insure adequate intake air temperatures are maintained
Cold Weather Concerns
Throttle Plate
– Check/Stop engine lamp and possible shutdown
– Fault Codes: 2758 & 2759 Frozen Intake Manifold Pressure/Temperature Sensor
– Check engine light and poor engine performance
– Fault Codes: 124 & 125 Ice build up in Low Pressure Regulator
– Check engine light for low fuel pressure
– Fault Codes: 2991 & 2776
4
Throttle Plate Fault Codes 2758 & 2759
Issue
– Faults are caused by ice forming on and around the throttle plate
– Moisture from charge air cooler(CAC) is forming the ice
Solution
– Block air flow across CAC using winter front or similar device
– Warm intake air ahead of CAC
5
Frozen Intake Manifold Pressure / Temperature Sensor Fault Codes 124 & 125 Issue
– Condensation collects on sensor and freezes while engine is not running
– Intake manifold pressure sensor is failed low (in range) and the ECM calculates low air flow
– Causes low power and fault codes
Solution– Replace sensor or dry current sensor
– Block air flow across CAC using winter front or similar device
– Supply warm intake air ahead of CAC
– Prevent sensor freezing using a heater if parked over night
– Remove sensor from engine if heater not available
6
Ice build up in Low Pressure RegulatorFault Codes 2991 & 2776
Issue
– Condensation from air flow collects in low pressure regulator and freezes
– Regulator can not adjust fuel pressure
Solution
– Block air flow across CAC using winter front or similar device
– Warm intake air ahead of CAC
Cold Weather Operation
Tips & Aids
7
8
Cold Weather Operation
It is possible to operate engines in extremely cold environments if they are properly prepared and maintained.
Cold weather preparation and operation procedures for Cummins Westport natural gas engines are similar to diesel engines (block heater, coolant heater, battery warmer, radiator shutters etc.).
9
Cold Weather Operation
The correct engine coolant lubricating oil and fuels must be used for the cold weather range in which the engine is being operated:
Ambient Temperature 0 to -32C (32 to -25F)
– Use 50% ethylene glycol antifreeze and 50% water for the engine coolant mixture.
Ambient Temperature -32 to -54C (-25 to -65F)
– Use 60% ethylene glycol antifreeze and 40% water for the engine coolant mixture.
Refer to Section V (Lubricating Oil Recommendations) of the Cummins Owners Manual for correct specifications
Engine intake manifold temperature must be maintained above a minimum of 0 (32 F), and coolant temperature must be above 60C (140 F) in thermostat housing at idle
Lubricating Oil
10
Example of a winter 10W30
engine oil that meets
CES20074 specification
Cold Weather Operating Aids
Coolant, Oil and Battery Heaters, Warm Intake Air,as well as Radiator Shutters/Winter Fronts are required for engine operation below 11 F (-12 C)
Starting Fluid
Due to potential engine damage, starting fluid should not be used. The use of starting fluid in a gaseous fueled engine has no practical purpose.
11
Excerpt from ISL G
Owners manual.
Cold Weather Operating AidsExamples Winter Fronts Oil Heaters Coolant Heaters
Warm Underhood Intake Air
12
OEM Supplied Fuel System Components(Both CNG and LNG Systems)
Mounted on the vehicle Regulates fuel storage pressure (3,000 psi) down to engine pressure (70-150 psi) Fuel heater supplied with warm engine coolant to prevent freezing Fuel pre-filter mounted near engine has a daily drain requirement
Fuel Management Module (FMM)
The service pressure is 3,600 PSI.
¼ turn Main Shut Off Valve
Isolates components downstream including those enclosed inside the Fuel Management Module to manually shut off fuel supply to the engine and filter/regulator assembly components.
Install information
Water Volume in Liters
Agility Install Location
Date of Installation
Tank Expiration Date
Low & High Pressure Gauges
Indicates incoming fuel pressure downstream of the fill receptacle and storage cylinders and upstream of the final engine plumbing circuit.
Indicates cylinder fuel level and pre-regulator pressure reading.
Two Fill Receptacles on this FMM
Fuel travels through the main shut-off valve into the main fill line and fuel cylinders.
Contains an internal check valve to prevent fuel loss during coupling and uncoupling the fill nozzle14
15
Fuel Management Module
Service high pressure fuel filter per OEM requirements
Cold Weather Tips
Natural gas fuel system pressure regulator is kept from freezing with a supply of warm engine coolant
– In cold weather, it is important to allow the engine to warm to operating temperature before operating under load to prevent possible fuel system freezing and other potential engine shut down issues (i.e. low oil pressure)
For cold weather starting. it is also important to minimize parasitic load on the engine at start by turning off PTO accessories like hydraulic pumps, etc
For proper engine operation, engine intake manifold temperature must be maintained above a minimum of 0 (32 F), and coolant temperature must be above 60 C (140 F) in thermostat housing at idle
16
Fuel Filter (Spin-on Type) - Drain
Shut off the engine. Use your hand to open the drain valve. Turn the valve counterclockwise approximately 1-1/2 to 2 turns until draining occurs.
Drain the oil from the fuel filter When closing the drain valve, do not
over tighten the valve. Over tightening can damage the threads. Turn the valve clockwise to close the drain valve.
No more than one ounce of oil in the fuel filter
18
Fuel Filter Draining Oil
Cold Weather Tips
Dry fuel is an important consideration for cold weather operation.
Water/oil captured in fuel filter can freeze and affect engine performance.
CNG filling stations should include a dryer to remove moisture from the natural gas.
If daily fuel filter check drain reveals more than 1 ounce of water/oil, contact your fuel station provider.
19
20
Resources
Cold weather requirements for Cummins diesel and natural gas engines are the same
Guidelines are published in ISL G CM2180 and ISX12 G CM2180 Owners Manual and Operation and Maintenance manuals
Cummins AEB 174.04 – Cummins internal
– Guidelines for Cold Weather Engine Operation for All Automotive and Industrial Engines
Cummins Technical Service Bulletin (TSB) 3379009
– Operation of Diesel Engines in Cold Climates Cummins Technical Service Bulletin (TSB) 4332709
– Operation of Natural Gas Engines in Cold Climates Cummins Technical Service Bulletin (TSB140013) “ISLG & ISX12 G
Fault codes while Operating in Low Ambient Temps below Freezing”