Post on 29-Mar-2020
transcript
AnAkin'S jedi StArfighter ™ KIT 1864 85186400200
If you have any questions or comments, call our hotline at: (800) 833-3570or, please write to:
Revell Inc Consumer Service Department, 1850 Howard Street Unit A, Elk Grove Village, Illinois 60007Be sure to include the plan number (85186400200), part number, description, your return address and phone number.
Visit our website: www.revell.com
Revell Inc Elk Grove Village, IL. Copyright © 2009. All rights reserved.
During the Clone Wars the Jedi Order deployed the single seat, tapered starfighter of the Galactic Republic in large numbers. A typical feature of this Delta-7B starfighter is the position of the astromech droid (in Anakin's case R2-D2) just fore of the cockpit instead of next to it. The relatively light armament is explained by the Jedi's confidence in their own skills of conflict avoidance. Its modest dimensions also offer too little space for its own hyperdrive. This extremely light short starfighter is well protected against bombardment. The four laser cannons it carries with it are partly concealed. Anakin uses a Jedi starfighter, among other things when rescuing Jabba the Hutt's son, Rotta.
* REPEAT SEVERAL TIMES* A REPETER PLUSIEURS FOIS
* REMOVE AND THROW AWAY* A RETIRER ET JETER
* TRIM* D´ECOUPER
* OPTIONAL PARTS* PIECES EN OPTION
Á LIRE AVANT DE COMMENCER
• DÉGAGGEZ UN ESPACE POUR TRAVAILLER.
• ÉTUDIEZ LES ÉTAPES DE MONTAGE AVANT DE COMMENCER.
• CHAQUE PIÉCE EN PLASTIQUE PORTE UN NUMÉRO DE PIÉCE.
• CETTE MAQUETTE L´ASSEMBLAGE PAR SIMPLE PRESSION, MAIS VOUS POUVEZ COLLER LES PIECES SI VOUS LE PREFEREZ. • D´ECOUPER POUR ENLEVER LE PLASTIQUE
SUPERFLU ET BIEN LIMER AVANT L´ASSEMBLAGE DES PI´ECES
MISE EN GARDE: POSITIONNEZ AVEC PRÉCAUTION TOUTES LES PIÉCES
DE CE MODÉLE RÉDUIT, CAR VOUS NE POUVEZLES EMBOîTER QU’UNE SEULE FOIS.
READ BEFORE YOU BEGIN
• CLEAR A SPACE TO WORK ON.
• STUDY THE ASSEMBLY DRAWINGS BEFORE YOU BEGIN.
• EACH PLASTIC PART IS IDENTIFIED BY A PART NUMBER.
• THIS KIT MAY BE SNAPPED TOGETHER BUT PARTS MAY BE CEMENTED IF YOU PREFER.
• TRIM TO REMOVE EXTRA PLASTIC AND FILE
SMOOTH BEFORE PART ASSEMBLY.
CAUTION:
POSITION ALL PARTS IN THIS KIT CAREFULLY. PARTS WILL ONLY SNAP TOGETHER
ONCE.
© 2009 Lucasfilm Ltd. & TM. All rights reserved. Used under authorization.
Step 1
Kit 1864 - Page 2
6
25
3
4
1
8
10
7
9
2nd
1st
2nd
1st
CompletedCockpit
Assembly
Cockpit Assembly
CompletedCanopy
Assembly
Canopy Assembly
Step 2
Kit 1864 - Page 3
Step 4
Step 3
17
12
15
13
16
14
11
24
20
26
23
2119
2522
18
Completed Assembly
Step 1
Completed Assembly
Step 2
Completed Assembly
Step 3
LANDING GEAR UP
LANDING GEAR DOWN