KTM RC 250 MOTO3/FACTORY 2012

Material included in the bike sale package

1. Chassis Spec Factory chassis 2012 factory

Geometry Checked by laser system (with documentation)

Headstock inserts

-6/-1º

-6/-0.5º

Pivot point inserts

+/- 6

+/- 5

+/- 4

+/- 3

+/- 2

+/- 1

0

Tripple clamp (magnesium t. clamps)

Offset 28mm

Offset 30mm

Footrest

-10 mm with heel protector

Handlebar clamps

+ 10mm

Standard on the bike

Rizoma front brake lever protector

2. Suspensions 2012 WP Fork upgraded (Extension plug / new valving 2a1j / top out spring fully engaged )

2012 WP Shock upgraded (Top out spring 155 x 7

2013 WP Steering damper

3. Body Work 2012 top fairing modified (enlarged side areas)

Belly pan modified (front part for using -6/-1º headstock insert + sides for using Akrapovic 2013 twin exhaust).

Rear tail carbon pad + 75 mm

Rear fender large

Swingarm carbon protector

Cranckase oil breather reservoir with silicon hoses

Airbox cover with heat isolation

4. Engine 2012 factory engine upgraded

Conrod + piston kit factory 2013

Cylinder head 2012 with ports upgraded

Camshaft + valves kit factory 2013

Gearbox standard (E option + primary 64)

Suter Slipper clutch

Exhaust:

Complete exhaust Akrapovic 2012 evo 4 with coating

Complete exhaust Akrapovic 2013 twin with coating

5. Throttle body 2012 factory spec upgraded with heat protection on carbon plate

6. Cooling system / fuel tank 2012 Factory radiator MB with Venair heat protected silicon hoses

2012 Factory evo 3 fuel tank with heat isolation

Fuel line with heat protection

Fuel line connector Stäubli

7. Brakes / wheels Front brake line

Front brake pump Brembo 16 x 16 with short foldable lever

Front caliper brembo for double disc system

Front brake disc Brembo 4 x 218 m with special bolt for front wheel speed 2D sensor

Rear brake line

Rear brake pump Brembo factory with brake fluid reservoir integrated

Rear brake disc Brembo 4 x 190 mm with sensor wheel for rear wheel speed sensor

Brembo rear wheel caliper

Wheels 2013 Magnesium OZ Cativa

8. Electronics 2012 factory electronics that included:

Dellorto ECU with 2012 firmware

Dellorto Dash

Front / Rear Brake Pressure sensor

Front 2D Speed Sensor

Rear KTM Speed Sensor

Airbox Pressure Sensor

Engine Sensors - TPS sensor - BPS sensor - Water / Oil Temperature Sensor - Oil Pressure Sensor - Fuel Pressure Sensor - Gear position sensor - RPM Sensor

Widelambda sensor

Front / rear suspension sensor

Quickshifter factory 2012

Battery: - Battery factory 2012

9. Spare package with bike 1 set of handle bar + clamps complete

1 set of footrest complete

1 set of rims complete with brake disc

1 set of bodywork complete

2 battery

2 rear shock springs ( 1 step over and 1 step below the one on the bike)

2 pairs front springs (1 step over and 1 step below the one on the bike)

PRICE FOR THE TOTAL PACKAGE BIKE + ABOVE MENTIONED PARTS

28.000€

Optional material for the bike PRICE Spare engine complete 2013 spec with 1600 km total 4000€