Post on 22-Sep-2020
transcript
The “ACE” Advantage. . .Securit y for your next masonr y project .
1-800-457-4056 www.hyload.com
Lifetime Warranty
pe
1. Hyload Flashing Membrane Is built into the back-up wall or attached with a termina-tion bar, which is optional. This tough waterproof ma-sonry flashing, when combined with pre-formed shapes provides an excellent moisture barrier. The 40-mil mem-brane is fiber reinforced to resist jobsite conditions.
Hyload Surface Adhered Membrane With DRIP Can be surface mounted to block, gypsum/stud or concrete back up wall. The 40-mil composite membrane is 25-mil of the Hyload Flashing Membrane and 15 mil of rubberized asphalt with release paper. The DRIP is formed by holding back the rubberized asphalt 1-1/2” from the exterior edge of the membrane. This allows for the proper construction of the soft joint detail at the relieving angle and eliminates costly and dangerous metal DRIP edges. A termination bar is optional with this membrane.
Hyload Surface Adhered Membrane without DRIP A 40-mil membrane comprised of 25-mil of Hyload Membrane and 15-mil of rubberized asphalt with release paper. A stainless steel drip edge should be used to bring the flashing through the wall. A termination bar is op-tional with this membrane.
The Hyload HyTUFTM Flashing System provides:• Unique flashing membranes for today’s varied construction situations.
• Preformed three-dimensional shapes to detail your project.
• Sealant Compatibility.
• UV stability, not available with other membranes.
• Four colored membranes to match mortar. Gray, Tan, White, Black
• “EZ-Flash” Pre-assembled flashing system.
• Lifetime Warranty
pe
1-800-457-4056 www.hyload.com
PRE-FORMED SHAPES
EZ-FLASH ASSEMBLY
2. Pre-formed ShapesAre three-dimensional shapes eliminating the need for jobsite detailing. Pre-formed shapes negotiate changes in direction and elevation and control water movement. The one-piece construction has no seams. The vertical to horizontal transition of the shapes is a 3/8” radius for easy and secure membrane installation.
3. EZ - Flash SystemIs a pre-assembled flashing system that includes a termination bar, Hyload flashing membrane, and a flex-ible drip edge, all made from the same quality Hyload materials. Available in 12” and 18” widths and up to 25’ rolls custom sizes available by request.
4. Extruded AccessoriesUnique extruded membrane shapes to facilitate other applications. 1”x 1” 90 degree. Slip Trac Joint baffel, and a flexible dripedge.
5. Sealant CompatibilityAll Hyload Flashing Membrane systems and accessories are compatible with silicone and urethane sealants. Hyload membranes eliminated the need for metal drip edge and allow for the proper installation of the soft joint detail at the relieving angle. Flexible drip edge is available as well. Refer to website for sealant compatibility information.
6. UV StabilityThe unique Hyload Membranes are UV and ozone stable and can be left exposed indefinitely during the construction phase of any masonry project.
7. Colored MembranesAll Hyload Membranes are available in the following colors: white, gray, tan or black. This feature allows the designer to bring the flashing through the wall and form a DRIP in an architecturally pleasing manner.
OUTSIDE CORNER 135 INTERNAL CORNER CAP INSIDE CORNER 90
INSIDE CORNER 135 EXTERNAL CORNER CAP END DAM “A”= 4”, 6”, 8”, 10”, 12” STOP END “A”= 4”, 6”, 8”
LEVEL CHANGE 3” LEVEL CHANGE 4”
COLONIAL WILLIAMSBURG, VA
STANDARD PRE-FORMED SHAPES
OUTSIDE CORNER 90
CUSTOM SHAPES
STEP BACK 4” NUT COVER 2”
1”
2”
1-1/2”
STEP BACK 2”
EZ -FLASH ROLL
SPRINT, OVERLAND PARK, KS
STOP END “A”= 4”, 6”, 8”
TYPE W1 TYPE W2 TYPE W3 TYPE W4
TYPE W5 TYPE WL1 TYPE WL2 TYPE 444
WINDOW CORNERS
3"
3"
3"
4"
1"
4"4"
4"
2"
2"
2"
4"6"
2" 1-1/8" 1-1/2"
4"
4"
4"
4"1-1/2"1-1/2"
2"
4"
3-1/2"
1-1/2"
2"
2"
4"
3-1/2"
1-1/2"
4"
2"2"
Hyload Mastic
Builder PaperOverlapping Flashing
End Dam 6"
Mastic Lap
4" Min.
Weep
3 5/8"Brick
2"Airspace
1/2" Backer Rod
1/2" Sealant1/4"
Concrete Blockw/Mortar
Hyload FlashingMembrane
Hyload FlashingMembrane
Steel Angle-Sizeto Vary
ConpressableFiller
Concrete
ConcreteBlock
3 5/8"Brick
2"Airspace Concrete
Full HeadJoint Weep
1/4"Sealant
Backer Rod
MasticGypsum Sheeting
Sheating Paper
Surface Adhered w/DRIP Membrane
Steel Angle-SizeTo VaryCompressable Filler
Gypsum Sheating
HyloadMastic
Full HeadJoint Weep
Hyload SurfaceAdhered w/DRIP Membrane
Grade
GroutSolid
WaterproofingSystem
6" Overlap
COMMON DETAILS
1-800-457-4056 www.hyload.com
HYLOAD SURFACE ADHERED WITH DRIP MEMBRANEMEMBRANE AT FOUNDATION
MEMBRANE AT SHELF ANGLE - BLOCK BACK-UP MEMBRANE AT SHELF ANGLE - GYPSUM BACK-UP
LIFETIME WARRANTY
• Material installed on projects aged well over 30 years
• Tested weathered material with little or no degradation
• Hyload tested a 22-year-old membrane from an installation on a building at the University of Kentucky, exposed it to the harshest of conditions. The membrane passed every test and is still passing them today.
Hyload HyTUFTM Flashing system has proven chemistry.......This is why we feel comfortable offering security for our customers
1-800-457-4056 www.hyload.com
W HOTEL, TIMES SQUARE, NEW YORK, NY
NOTABLE PROJECTS
TURKISH EMBASSY, WASHINGTON, D.C.
SOUTHERN R.R. HEADQUARTERS, KANSAS CITY, MO
NATIONWIDE ARENA, COLUMBUS, OHWALGREENS, EVANSVILLE, IN
CORPORATE HEADQUARTERS5020 Panther Parkway
Seville, Ohio 44273info@hyload.com
Phone: (800) 457-4056Fax: (330) 769-4153
www.hyload.com