Post on 15-Nov-2014
description
transcript
MAGIC LAMPWith arduino uno
D3 – RACE
‘2A’
When or
where we used
it ?
What is the temperature lamp ?
Which kind of system that this temperature lamp is used ?
How can it work ?
LIST
NEXT
What Is The Temperature Lamp ?
Temperature Lamp is a
lamp that we can used it for
light some places with
different function of different
colors of that lamp.
When Or Where Can We Used It ?
We can used it in
everywhere but, if we wanted to
get a nice performance, we
should have to put it on the dark
places. Because this lamp its
especially used for your
bedroom.
So when you sleep, you just
not to get one kind of colors
lamp, but you can see some
different colors of your lamp.
.
Which Kind Of System That This Temperature Lamp Is Used ?
This lamp are built with three steps
that can make one system, these
steps are :
1.We used Arduino Uno and other
components
2.We used electrical series
3.We used some coding for the
system
.
Which Kind Of System That This Temperature Lamp Is Used ?
These are components that
we used for build
temperature lamp :
Arduino Uno&USB Cable
Laptop / pc
FrameworkOf
lamp
Casing
Of
arduino
LED (red,blue,white
)
Resistor of the lamps (100µ)
TIN SOLDER WIRE,
solder, unsoldering
LDR
Resistor of LDR (10 kµ)
LM 35
CONNECTOR CABLES
PIN HEADER&
BLACK HOUSE
pcb
Which Kind Of System That This Temperature Lamp Is Used ?
These are steps to make the
temperature lamp :
1. Prepare all of components and
make sure that all of it worked
2. Make an electrical series like this
picture. But remember, we should
have to pair it with voltage
source (adaptor 5 V).
Which Kind Of System That This Temperature Lamp Is Used ?
3. Combine two series of
electrical (LDR and LM35)
then put it on the PCB (in
here, we also use solder and
so on)
4. Turn ON the Arduino Uno and
make some coding like this…
Which Kind Of System That This Temperature Lamp Is Used ?
5. And after that, put the arduino
uno in the box or casing from
acrylic.
6. After all of components ready to
used, then we put it on the
framework of the lamp.
7. Finally, we can turn on the lamp
with adaptor or other power
supply.
MAGIC LAMPWith
Arduino Uno
THE RESULTS….
How Can It Work ?This lamp can work (or the lamp will turn on) when
we put it on the dark places. Why? Because when we
make the coding we set the sensor value of LDR is
less than 500. So its mean when the sensor read no
light around it, so the LED will turn ON. And the other
way, when the sensor read light around it, the LED
will turn OFF.
And how about the difference colors of the lamp?
This is the special of our lamp. Its not just one
kind of color, but we can turn ON three kind of colors.
We can call it temperature lamp because with LM 35
we can set one colors which has some range of
temperature around it. So this lamp is not only for
lighting, but this lamp can be used to for measuring
temprature. ^^
SOURCE
http://www.ladyada.net/
learn/sensors/tmp36.html
THANK YOU FOR YOURATTENTION ^_^