Post on 15-Jan-2016
transcript
1
Maintenance and
Preventive Maintenance
Principles of Manufacturing
Copyright © Texas Education Agency, 2012. All rights reserved
2
The following presentation explains:
• Machine maintenance• Preventive maintenance• Storage areas• Waste storage• Waste removal
Copyright © Texas Education Agency, 2012. All rights reserved
3
Machine Maintenance
Copyright © Texas Education Agency, 2012. All rights reserved
4
Student Equipment Maintenance
• change blades on basic machines• make approved adjustments • clean machine and work area• report any missing parts or broken parts• report any strange noises
Copyright © Texas Education Agency, 2012. All rights reserved
5
Student Preventive Maintenance
• cleaning of machines (outside and inside any doors)
• check correct installation of guards• do not disassemble any equipment
Copyright © Texas Education Agency, 2012. All rights reserved
6
Maintenance Safety Rules
• Machines that you are working on should be unplugged.
• Caution should be taken with the blades of knives both dull and sharp. Both types of cutting edges can harm you.
• Safety glasses must be worn at all times because of dust while cleaning.
Copyright © Texas Education Agency, 2012. All rights reserved
7
Improper Maintenance
• Improper or no maintenance will shorten the life of the equipment.
• Improper maintenance can make the machine unsafe to use.
Copyright © Texas Education Agency, 2012. All rights reserved
8
Material Storage
Copyright © Texas Education Agency, 2012. All rights reserved
9
Supply Storage
Lumber can be stored on racks or in stacks. Plywood can be stored in racks orleaned against a wall. Metal, like wood, can be stored inracks or shelves.
Copyright © Texas Education Agency, 2012. All rights reserved
10
Supply Storage
Supplies should be stored in cabinets with some kind of controlled access.
Copyright © Texas Education Agency, 2012. All rights reserved
11
Tool StorageTools should be stored in a cabinet or rack.Tools should have a place in the cabinet or shelf.There should be an accountability for tools:tool check-out formassigned place for each tool
Copyright © Texas Education Agency, 2012. All rights reserved
12
Student Project Storage
• There needs to be a location in which the students can place their projects for storage.
Student project cages
Copyright © Texas Education Agency, 2012. All rights reserved
13
Finishing Material Storage
• The finishing materials should be stored in a flame resistance cabinet. All finishes, stains and thinners should be in the cabinet.
Copyright © Texas Education Agency, 2012. All rights reserved
14
Waste Material
Copyright © Texas Education Agency, 2012. All rights reserved
15
Waste Material Storage
• Metal shavings and small pieces of metal can be thrown away or recycled. Small amounts of aluminum, brass, and copper can be stored and then easily recycled. Steel and iron are recyclable, but prices are so low it might not be practical. All metal must be stored in separate containers.
• Storage of unused finishing products should be labeled and stored in an approved cabinet.
Copyright © Texas Education Agency, 2012. All rights reserved
16
Waste Removal
• Sawdust and small scraps of wood can be thrown away in the trash.
• Non-recycled metals can be thrown away in the trash.
• The finish waste must be disposed of in the school approved manner.
Copyright © Texas Education Agency, 2012. All rights reserved
17
Resources
• OSHA requirements for woodworking machines:http://www.osha.gov/pls/oshaweb/owadisp.show_document?p_table=STANDARDS&p_id=9837 • A Guide for Protecting Workers from
Woodworking Hazards:http://www.osha.gov/Publications/osha3157.pdf
Copyright © Texas Education Agency, 2012. All rights reserved