Post on 15-Dec-2018
transcript
force668LM
manual
MANUAL CONNECTING POWER SUPPLY FORCE668LM SLIDE BOLT
Unscrew 4 torxscrews in de ForceIQ control box and put the control board upside down take the power supply out of the box
Plug the power supply connectors onto the main board (will only fit one way)
Snap the power supply onto the plasRc rail of the circuitboard housing
Replace the control box housing in the main control box and Rghten the 4 torx screws
manual – force669LM
2www.flexiforce.com
ConnecRng LM668 to Force IQ control box. If lock works the wrong way round then swap KL14 and KL15
manual – force669LM
3www.flexiforce.com
PROGRAM LOCK 668LM IN FORCE IQ SPECIAL SETUP
SPRECIAL SETUP AUTO CLOSE
SPECIAL SETUP AUTO OPEN
SPECIAL SETUP PARTIAL OPEN
R1 TYPE INACTIVE
MODE LOCK OPEN
SPECIAL SETUP RELAYS
R1 TYPE END POS.
R1 TYPE MOVEMENT
R1 TYPE EL.LOCK
RELAY 1 INACTIVE
PRERUN 1 SEC
CONFIRM:SAVE OTHER KEY: ESC.
manual – force669LM
4www.flexiforce.com
R2 TYPE INACTIVE
MODE LOCK OPEN
RELAY 1 EL.LOCK
R2 TYPE END POS.
R2 TYPE MOVEMENT
R2 TYPE EL.LOCK
RELAY 2 INACTIVE
MODE LOCK CLOSE
CONFIRM:SAVE OTHER KEY: ESC.
RELAY 2 EL.LOCK
SPECIAL SETUP RELAYS BACK TO MAIN MENU
PROGRAM LOCK 668LM IN FORCE IQ SPECIAL SETUP
SPRECIAL SETUP AUTO CLOSE
SPECIAL SETUP AUTO OPEN
SPECIAL SETUP PARTIAL OPEN
R1 TYPE INACTIVE
MODE LOCK OPEN
SPECIAL SETUP RELAYS
R1 TYPE END POS.
R1 TYPE MOVEMENT
R1 TYPE EL.LOCK
RELAY 1 INACTIVE
PRERUN 1 SEC
CONFIRM:SAVE OTHER KEY: ESC.
PROGRAM LOCK 668LM IN FORCE IQ SPECIAL SETUP
SPRECIAL SETUP AUTO CLOSE
SPECIAL SETUP AUTO OPEN
SPECIAL SETUP PARTIAL OPEN
R1 TYPE INACTIVE
MODE LOCK OPEN
SPECIAL SETUP RELAYS
R1 TYPE END POS.
R1 TYPE MOVEMENT
R1 TYPE EL.LOCK
RELAY 1 INACTIVE
PRERUN 1 SEC
CONFIRM:SAVE OTHER KEY: ESC.
manual – force669LM
5www.flexiforce.com