Mother’s day corsage tutorial

transcript

www.embroideryonline.com

Mother’s Day Corsage Tutorial

by Micah Schrock

FeaturingFreestanding Lace Bouquet

#12454

Stitch and assemble the orchid according to the collection instructions.

Make a bow from organdy ribbon (you’ll need about 24” yard) – choose colors to match your flower, or stitch your

flower to match your ribbon!

Create four loops (or more if desired). For an even bow, make loops on alternate sides in a

figure-8 pattern.

Use a piece of floral wire approximately 4” long. Twist it around the center of your ribbon to secure.

Twist the tails of your wire together –you will use this “stem” to attach the

ribbon to your corsage.

Choose some silk floral accent floral pieces, and arrange as desired behind

your lace flower.

Align the stems of your accent florals with the floral wire at the bottom of your orchid. Hold

together with one hand. With the other hand, begin to wrap the pieces together with

floral tape.

Continue to wrap with floral tape. You may need to cut off some of the floral wire and floral stems.

Leave about 1 1/2” of stem at the bottom of the orchid.

Now, add your ribbon, aligning the wire “tail” with the orchid stem. Wrap stem and wire together with floral tape. If creating a

lapel corsage, pin on with a corsage pin.

To create a wristlet, form a circle of elastic and stitch together.

Use a double seam to secure the elastic together. Be sure to make the elastic

circle small enough that it has to stretch slightly in order to fit.

Align the elastic circle with the stem, placing the seam against the stem so it will

not show.

Secure the elastic to the corsage with a piece of wire.

Wrap both the wire and elastic with floral tape. Tear off the tail of the floral tape and wrap it back around the

stem to secure the end of the tape. Stretch the tape as you wrap the tail to secure it tightly.

And now you’re ready to present your gift! Mom will love showing off her

corsage on her special day!

Self Improvement