By: Dennis Lee & Wojciech Kimborowicz

SOLID WORKS

The Staircase

assemble was

designed in

SOLIDWORKS.

It consists of six 3D

models

Bracket

Universal Bracket is used to support a staircase step, 2 are required per 1 step.

DETAIL

Universal Bracket is used to support a staircase step, 2 are required per 1 step.

(2) 2x6 are used in this assembly, they are the skeletons of the staircase. They have a 45° cuts on each end.

(2) 2x6 are used in this assembly, they are the skeletons of the staircase. They have a 45° cuts on each end.

Step can be used of all

kinds of wood, in our

case we used Oak.

Step can be used of all

kinds of wood, in our

case we used Oak.

A 1” Phillips screw

was used to Bind all

the Parts together

A 1” Phillips screw

was used to Bind all

the Parts together

No. Description QTY.

1 Support Bracket 8

2 2x6 Beans 2

3 1” Phillips screw 16

4 Oak Baseboard 91/2 X 36” 4

5 Floor (reference only) 1

6 Wall (reference only) 1

Bill Of Material