Pergo – solution for all areas Special Installation Instructions · Pergo – solution for all...

transcript

www.pergo4vw.comP 1

Special Installation Instruction

Pergo – solution for all areasSpecial Installation Instructions

Front office – Cherry Havana (Public Extreme)

art. no. 70601-4004

Highlight area

– Cherry Havana (Public Extreme)

art. no. 70601-4004

R / R-Line – Concrete Black (Original Excellence)

art. no. 70209-0465

2013-01-24

www.pergo4vw.comP 2

Different installation alternatives

1. Islands Std version, (11mm, Small, Mid, Big)

2. Islands, High (24mm, when Electric cables within the floor)

3. Front- & Back- Office

4. With Safe Seal (for higher strength and protection against wet cleaning.

www.pergo4vw.comP 3

Layout instructions and material calculations

Volkswagen High Light Areas, Std Version

Examples of standard size areas

Big 43,2 m² Medium 28,8 m² Small 25,2 m²

www.pergo4vw.comP 4

1. Standard Installation

• SafeSeal will prevent moisture from penetrating down into the jointsWhen SafeSeal, the floor will not be able to be disassembled

• EPDM moulding will prevent moisture from penetration down under

the profile

Eventual

www.pergo4vw.comP 5

Layout instructions and material calculations

Volkswagen High Light Areas, High Version

Examples of standard size areas

Big 43,2 m² Medium 28,8 m² Small 25,2 m²

www.pergo4vw.comP 6

Item List VW

www.pergo4vw.comP 7

2. Electric supply underneath the flooring

• Floating construction between 12 mm board and Pergo Public Extreme

• SafeSeal will prevent moisture from penetrating down into the jointsWhen SafeSeal, the floor will not be able to be disassembled

• EPDM moulding will prevent moisture from penetration down under the profile

Eventual

www.pergo4vw.comP 8

Advantages installing Pergo Extreme in Car Show Rooms.Pergo 11mm Public Extreme, Cherry Havana Art nr; 70601-4004.

• Staining of rubber tires into the floor surface (migration)It is known as a problem in car show rooms that rubber tires and especially modern soft winter tires give black or

brown migration marks on the floor. Pergo floors withstand all common car tires for a long period standing on the

same spot without showing migration or discoloration.

• Weight of the carPergo floor does not have any restriction for normal private cars with regards to the weight of the vehicle.

However, if the weight of the car exceeds 2.000 kg, the car should be pushed or towed to the floor or alternatively

very, very gentle driven.

• Spike (studded) tiresAre not allowed, unless protection is used, both when the vehicle is driven up on the floor and when it is finally

placed at the floor. (Protection Plates under the wheels)

• Adding extra strength and moisture protectionPergo recommends installation with Pergo Safe Seal, to give extra strengths of the installation and safeguard

against moisture, wet cleaning and allow larger installation areas without expansion joints.See Separate SafeSeal instruction.

But, When using SafeSeal, the floor can not be disassembled, without getting damaged.

www.pergo4vw.comP 9

Installation instructions, ALU Ramp Profile

Cut off underlay

material min 20 mm.

1. Put PE foil on the subfloor

2. When Safeseal is needed, apply in the bottom of the groove before assembling.

Ev. Excess SafeSeal can be peeled off after drying or wiped of with slightly damp and carefully wrung out mop, Change Water regularly

3. On the outer edges of the floor (long and short sides), cut off 20 mm of the backing material before installing.

3. Put construction glue on lower leg of the ramp profiles.

4. Tap the profile to a stop.

2. SafeSeal

www.pergo4vw.comP 10

PerfectFold™ joint technology

Installation technique:

• Rotating the long side,

the short side will be locked at the same

Developed for the toughest commercial

demands.

Wall distance / expansion joint

Because Pergo flooring is made from organic materials, your floor will naturally expand and contract as the temperature and relative humidity change. The ideal indoor environment is 40 -

60% RH, which results in almost no movement whatsoever. Pergo flooring is known to work very

well in the range of 30 - 75% RH provided some important rules are followed during installation.

As a General Rule, Leave 1mm in expansion joint, for every meter floor installed, (Length & Width)

The recommended maximum floor size is 10x10 m in a rectangular room before you will need to

install transition moulding as expansion joint.

However, if humidity consistently remains within 40 - 60% at normal room temperature you can

expand the floor size to 15x15 m. Transition moulding will be needed for doorways and rooms with angles, columns, etc.

Pergo floors can also be installed in larger areas using SafeSeal in the long side joints.

Maximum Area in this case is; 16x16m with a humidity interval up to 30 – 75% RH.

Half plank staggered between short end joints.

SafeSeal

Safe Seal for enhanced water security.All Pergo flooring has impregnated joints for good resistance to water spills and manual cleaning. In some cases,

there is a need to reinforce the basic security to water. This may be the case in some parts of public areas. In

shop entrances and similar, it may in some applications be a need to enhance the built-in protection. For this

purpose, Safe Seal is used.

Safe Seal for Large Installation Area.Based of the high content of natural wood based material used in Pergo floors there is a natural preference to

expand and contract as a result of its hygroscopic properties. Safe Seal can also be used as a supplementary support for installation of larger areas.

Safe Seal is applied only at long side of the plank in the bottom of the groove.

Safe Seal should not be used in the short end joint.

The design of the short end joint does not leave any space for any additional sealant. Additional sealant in the

short end joint will cause non acceptable height differences.

SafeSeal should be used in areas exceeding 10X10m with an indoor climate variation exceeding 40 – 60%RH,

but not higher then 30 – 75%RH, or where extra moisture protection is needed like the Dialog area and where

cleaning machines are used.

Maximum area with SafeSeal is 16x16m without expansion joints, Max Indoor climate variation of 30 – 75%RH

In areas where the floor should be disassembled, do not use SafeSeal

How to apply SafeSeal

SafeSeal is applied only at long side of the plank in the bottom of the groove before assembling.

Safe Seal should not be used in the short end joint. The design of the short end joint does not leave any space for any additional sealant. Additional sealant in the short end joint will cause non acceptable height differences.

Eventual excess sealant spilled on the floor should be removed a.s.a.p. (as soon as it becomes transparent, do not let it dry too hard). Wipe it of with a slightly damp and carefully wrung out mop, Change Water regularly.

Normally SafeSeal should not trickle up through the joint, if so, too much SafeSeal is applied.

Wall distance / expansion joint.

Back Office and islands against wall.

Fixed / heavy installations

When “fixed installations” a spacer or a spacer pad, must be used. There should be at least 1 mm space between the floor and the “fixed installation”. (Vertical)Drill holes with at least 15 – 20mm space (Horizontal) between the floor and the “spacerBlock” or any “fixed” item, to allow movements in the floor.

Pergo4VW Presentations

• Main Concept Presentation

• Item Specifications (Excel and pdf)

• Special Installation Instruction

• General Installation Instruction

• Maintenance Instruction

• Guarantee

• Contact List, Pergo

• Find them at www.pergo4vw.com

Pergo Contact persons VW project

- Germany Thomas Lenck +49 174 242 88 87 Thomas.Lenck@pergo.com- Austria Thomas Lenck +49 174 242 88 87 Thomas.Lenck@pergo.com

- Switzerland Felix Bucher +41 79 669 6508 Felix.Bucher@pergo.com

- Spain Gloria Lopez +34 659 46 60 40 Gloria.Lopez@pergo.com

- France Stéphanie LE +33 1 41 39 96 96 stephanie.le@pergo.com

- Italy Maurizio Galli +39 388 1287794 Maurizio.Galli@pergo.com- Holland Jos De Werd +31 653 25 66 22 Jos.Dewerd@pergo.com

- Belgium Frédéric Floss +32 475 73 01 28 Frederic.Floss@pergo.com

- UK Richard Price +44 778 52 32 866 Richard.Price@pergo.com

- Denmark Helle Bahnsen +45 21 79 41 31 helle.bahnsen@pergo.com

- Norway Leif Johansen +47 958 04 979 Leif.Johansen@pergo.com- Finland & Baltic Ismo Sihvonen +358 400-458 238 Ismo.Sihvonen@pergo.com

- Sweden Freddie Persson +46 070-531 97 83 Freddie.Persson@pergo.com

- Russia/Ukr Fedor Ustinov +7 916 685 16 99 Fedor.Ustinov@pergo.com

- Poland Leszek Dabrowski +48 66 77 30 690 Pergo@areco-sweden.pl- Czech Rep. Rune Nilsson +46 410 36 33 60 Rune.Nilsson@pergo.com

- North America Mike Nielsen +1 317-417-8874 Mike.Nielsen@pergo.com

- North America Katie McArthur +1 919 773 5857 Katie.McArthur@pergo.com

- South America Gloria Lopez +34 659 46 60 40 Gloria.Lopez@pergo.com

- South America Rune Nilsson +46 410 36 33 60 Rune.Nilsson@pergo.com- China Nancy Lan +86 (10 ) 65388764 Nancy.Lan@pergo.com

- India Naresh Maheshwari +91 11 41435741 Naresh.Maheshawari@pergo.com

- South East Asia Clifford Khoo +65 6787 8787 clifford.khoo@goodrichglobal.com.sg

- Others Rune Nilsson +46 410 36 33 60 Rune.Nilsson@pergo.com

Pergo – solution for all areas Special Installation Instructions · Pergo – solution for all...

Documents