Post on 31-Dec-2015
transcript
Next, grab a Switch icon and drop it into the loop. You may need to
hover over the loop for a second or twountil it goes inside the loop.
Switch the sensor to light sensorAnd put it on port 1. Also make
sure that “generate light” is selected and set the value at 50 for now.
You may have to tweak that number later.
Drag a second motor into the top switch. Make sure that:-Port A is selected-The direction is set to reverse-Power is set to 50-Duration is set to Unlimited
Drag a fourth motor into the bottom switch. Make sure that:-Port C is selected-The direction is set to reverse-Power is set to 50-Duration is set to Unlimited