Post on 23-Oct-2014
transcript
A Very Brief Introduction TO ISIS Proteus
CPE 110 Computer Exploration
August 21, 2009
1 1 Editing Window
2 2 Object Selector
3
A Guide To ISIS : Proteus
2 2 Object Selector
3 Overview Window
Tools and Buttons
Component List
Pick a DevicePick a Device
Ground and terminals
Signal generators(sources)
Instruments(Scope, meters)
Tools and Buttons
Device rotation
Device horizontal flip
Device vertical flipDevice vertical flip
Run a simulation
Stop the simulation
Pick a Device: LAMP
Click on P to pick a device.
Pick a Device: LAMP
Type Bulb to search for a light bulb
Double click on LAMP to select a lamp
Notice the LAMP in the Object Selector
Pick a Device: CELL
Type Battery to search for a battery
Double click on CELL to select a dry cell battery
Pick a Device: Push Button Switch
Type Button to search for a push button switch
Double click on BUTTON to select a push button switch
Pick a Device: Resistor
Type Resistor to search for a resistor
Scroll down the sidebar and look for RESDouble click on RES to select a resistor
Place a Device: CELL
Rotate a Device: Push Button
Select Button
Rotate a Device: Push Button
Click on Set Rotation button to set the rotation as shown
Draw a Circuit
The First Circuit
Run a Simulation
Pick a Device: Capacitor
Type Cap to search for a capacitor
Scroll down the sidebar and look for CAPDouble click on CAP to select a capacitor
The Second Circuit
Run a Simulation
The Second Circuit: Adding meters
The Second Circuit: Adding meters
Pick a Device: Sinusoidal Voltage Source (VSINE)
Type Vsine to search for a sinusoid voltage source
Double click on VSINE to select a VSINE
Notice the VSINE in the Object Selector
The Third Circuit: Resistive Circuit Response To AC
The Fourth Circuit: RC Response To AC
The Fourth Circuit: RC Response To AC
The Fifth Circuit: DC Amplifier using 741 OpAmp
The Fifth Circuit: Current Source Properties
The Sixth Circuit: AC Amplifier using 741 OpAmp
The Fifth Circuit: Voltage Source Properties