QOTD

•Conservation……..•3-5 sentences

The Law of The Law of Conservation of Conservation of MatterMatter

Conservation…• No matter is created or destroyed by such

changes!

• The total amount of matter remains constant.

How did scientists come up with this law?

•They measured the mass of the reactants (vinegar and baking soda) and then, after the reaction took place, they measured the mass of the products (reactants + carbon dioxide)

The Law of Conservation of Matter

• During a chemical reaction, matter cannot be created or destroyed.

• Even though the matter may change from one form to another, the same number of atoms exists before and

after the change takes place!

Since the overall mass of the matter does not change…• The mass of the reactants – the substances

there before the reaction occurs – must equal the mass of the product – the substances there after the reaction takes place.

Mass of Reactants

Mass of Products

An Example of the L.C.M.• Test tube containing lead lead

nitratenitrate is placed upright in a flask that contains potassium potassium iodideiodide.

• What are these?• REACTANTS!

• They don’t mix!

• A stopper is put in place to create a closed system – an environment where matter cannot enter or escape.

• The mass of the system is found.

• After the mass is found, the system is turned upside down so the lead nitrate can mix with the potassium iodide.

• They create lead iodide and potassium nitrate.

•Although the matter changed in form, the total mass of the system remains unchanged.

The Formation of Rust

• Iron• Hard, gray-colored metal

• Rust• Flaky, orange-red solid

When iron reacts with oxygen in the air, they form rust or IRON OXIDE.

•This is written as:Iron + Oxygen Iron Oxide

Fe Fe

Fe Fe

RE

AC

TAN

TS

Each made of TW

O

oxygen atoms

O2

O2 O2

PRODUCT

Fe2O3 Fe2O3

TAKE A LOOK AT

THE NUMBERS

How many Iron molecules?

How many Oxygen

molecules?

What about the

PRODUCT?

All Chemical Reactions follow the Law of Conservation of Matter • With Iron Oxide, the MASS STAYS THE SAME!

• The total number of iron atoms and oxygen atoms in the reactants is the same as that in the product.

• The atoms were just rearranged!• No new atoms were created and none were destroyed!

Determining the Mass of Reactants and Products• REMEMBER: The mass of the reactants is always equal

to the mass of the products.

Mass of Reactants

Mass of Products

Example: Tin Fluoride

• Tin + hydrogen fluoride -> tin fluoride + hydrogen

• What’s the total mass of the reactants?• 158.72 g

• So what should the mass of the products be?• 158.72 g

118.7 g

40.02 g

Total Mass of Reactants: 158.72 g

• Tin + hydrogen fluoride -> tin fluoride + hydrogen

• If we know the mass of the tin fluoride, can we figure out how much hydrogen was produced?• Subtract the mass of one product from the total mass.

156.71 g

2.01 g