Quick flux calculation for real time feedback

Injector holepattern

Intersectionof jets onplaten

Injector design

“jets.txt” files canbe imported

Various ways oftransforming data

Tabs select various functions

Jet number gets enteredautomatically by programas you enter the other data.

Parameters for calculation

Results of 2 dimensional calculationPlaten can be non-rotated, rotated, or partially rotated

Diameter plot for rotating platen

Tweak up and down

Checks for intersection of holes

Input hole diameter, plate thickness, andthe minimum acceptable clearance

To change axes on plots: Highlight value andtype in new value.

These controls autoscale the axes.

The lock toggles between autoscaleand fixed scale

There are also zoom controls

Right clicking on table pops-upa menu for manipulating data

Scale. Useful for adding smallIncrements of angle on selected jets.

Create series. Useful for creating ringsof holes or for spirals.

Multi-series. Alternates between 2 or 3different values. Green button selects2 or 3 values.

Randomize order of values in a selection

You get one “undo” for any of these transformations

All of these controls work on the data thatIs selected in the table

Blue curve is a reference you can saveto see if changes are helping or hurting.

Changes injector design back to stored design

Stores current designHide reference

When you first start the program you need tocalculate the flux curve otherwise it is all zeros.(even though the graph shows a curve to start)

Cartesian and polar plots of the fluxdistribution from each hole.

Data can be read in from external files.Data should be relative flux vs. angle in degrees.

2 different models are included in program.

Efficiency calculation calculates fraction of interceptedflux vs. platen radius.