RDSiR silicone rubber recycling chemical

Post on 08-Feb-2017

223 views 0 download

transcript

11

RDS Non-sulfur vulcanized Rubber Reviving AgentRDS-EPDM EPDM Reviving AgentRDS-CR CR Reviving AgentRDS-NBR NBR Reviving AgentRDS-CPE CPE Reviving Agent

Appearance: light yellow powder Application:RDS-EPDM、RDS-CR、RDS-NBR、RDS-CPE is respectively applicable to the revivingof EPDM, CR, NBR, CPE and non-sulfur vulcanized rubber.

Application Recipe:

Waste rubber

RDS

Total

100

2-5

102-105

100

2-5

102-105

Reviving Technique:1. Place the unqualified rubber products and production leftovers on the open mill after selecting, cleaning, removing sundries, drying and cutting into small pieces, break them with small roll pitch (≤0.2mm), and make them be powder after selection and classification.2. Refine the rubber powder and the RDS rubber reclaiming agent on the open mill for 15-30 min with roll temperature below 50℃. Corresponding softener can be added according to the condition, and after mill running and sheeting, the revived rubber can be got.Storage life: in cool and dry places for 2 yearsPackage: 25kg/bag

RDSiR Silicone Rubber Reclaiming Agent

waste silicone rubber

RDSiR

Total

Reclaiming Technique:1. Place the unqualified silicone rubber products and production leftovers on the open mill after selecting, cleaning, removing sundries, drying and cutting into small pieces, break them with small roll pitch (≤0.2mm), and make them be silicone rubber powder after selection and classification.2. Refine 20 meshes silicone rubber powder and RDSiR silicone rubber reclaiming agent on the open mill for 15-20 min with roll

Appearance: light yellow powder Application:applicable to the reviving of the waste silicone rubber under normal temperature. Application Recipe:

temperature below 50℃. Corresponding softener can be added according to the condition, and after mill running and sheeting, the reclaimed silicone rubber can be got.3. Notes: The reviving of silicone rubber is apt to mix on the open mill at low speed ratio; the higher the speed ratio the harder to sheet; it is recommended to operate on the open mill with the speed ratio of 1:1.1.Storage life: in cool and dry places for 2 yearsPackage: 25kg/bag