Operator/I&E MAINTENANCE BUILDING

REPURPOSING A COMPRESSOR BUILDINGLEAN INDUSTRIAL SERVICES

I was asked to come help the plant with their work processes. We agreed the first thing needed was a clean dry place to store electronic components. Since a new building was not an option, we had to repurpose.

Compressor Building

This building houses a compressor that was abandoned-in place and the best option available. This is a 12ft. X 24ft. building

Compressor Building

This building houses a compressor that was abandoned-in place and the best option available.

Compressor BuildingThis building housed a compressor that was abandoned-in place and the best option available.

I&E Maintenance ShopWe included a maintenance area and with the needed tools for their work.

I&E Maintenance Shop

Small consumables area, parts storage, and safety eye wash. Painting to be completed later, we worked up to the last minute finishing the room.

Tubing ConsumablesConsumables area with a simple system for triggering orders. Reorder amounts are clearly visible.

Tubing Consumables

Notice the “Red Binders” being used as “Reorder Triggers” for low quantities. When items are ordered, the clip is turned over to the green side.

I&E Maintenance ShopA section was made for “SAP Parts Storage”. These are parts controlled by mat’l mgmt.

I&E Maintenance ShopBlue Bins on the top are small “Project Boxes”

I&E Maintenance Shop

Safety Items and “Non SAP Parts Storage”

I&E Maintenance ShopAll “Power Tools” and “Tool Kits” labeled and put into the shop.

I&E Maintenance Shop

BEFORE SHOT AFTER SHOT

I&E Maintenance Shop

BEFORE SHOT AFTER SHOT