Post on 16-Aug-2015
transcript
Kamal Abdurahman
Group:B
11/2/2015
2015STEADY STATE GAS PERMEAMETER
Supervised By : Mr.Ali Kamal Ms.Sana Mr.Hewa
FACULTY OF ENGINEERING
SCHOOL OF PETROLEUM AND CHEMICAL
DRILLING ENGIEERING LAB
Contents
1 -Aim.
2 -Theory.
3 -Apparatus.
4 -Procedure.
5-Calculation.
6 -discussion .
7 -references.
Aim of experiment:
Used to measure permeability of samples such as oil well cores, tight gas
sandstones, and other low permeability rocks. Liquids such as brine, oil, and other
fluids are used. The machine measures drop in pressure and flow rate through the
sample during the test. PMI software uses Darcy’s Law to compute permeability.
Reference
http://www.malvern.com/en/products/measurement-type/rheology-steady state/default.aspx
Jiao, D. and M.M. Sharma, “steady state,” Journal of Colloidal and Interfacial Science, 1994. 162:p. 454-462.
http://www.glossary. steady state .slb.com/en/Terms/m/mudcake.aspx
Fisk, J.V., and Jamison, D.E., "Physical Properties of Rock at High Temperatures and Pressures," SPE Drilling Engineering, December 1989, pp. 341-46.