Post on 03-Jun-2015
transcript
TEKLINX PAKISTAN
Your Embedded Solution Partner
Industrial Instrument:Coupling Decoupling Network.
Equipment for EFT/Surge measurements, together with EFT/Surge generator.
Specifications: Frequency Range:
1MHz~100MHz Coupling Capacitance:
33nF Damping between the
output and the input: >20dB
Rated Load: 20A Line voltages: 380V Phase voltage:220V
Industrial Instrument: Dry Heat Test Oven
This chamber is used for test of heat stress on materials like Poly carbonate, ABS, Nylon etc.
It can also be used to simulate the aging effect of electronic accessories.
Specifications: Temperature Range: room temperature ~ 80’C Adjust able linear slope for
temperature rise Uniform heat flow across the
chamber Availability of Main voltage
terminals Computer interface Capacity: 4.5 cubic Ft
Industrial Instrument:Dust Chamber
Dust tests for equiment. Complies with
IEC60529 Specification:
Complies with IEC60529
Capacity: 10 Cubic Ft.
Industrial Instrument:Glow wire Tester
Used for testing the material properties on extreme temperature ranges
Specification: Temperature Range:
Max 1000 ‘C Adjustable contact
time Adjustable tension with
glow element
Industrial Instrument:Impulse Generator
Used for simulating the lightening surges.
Specification: Max voltage: 10KV Standard 1.2 / 50us
wave-form (+/-30%) Adjustable time between
the surges Adjustable surge count. Oscilloscope output for
impulse wave form viewing.
Industrial Instrument:Magnetic Tester For external Origin
Magnetic ring coil is used to test the EUT under magnetic field disturbances.
Specification: Max Flux: 0.5m Tesla Standard 1000 AT coil
Industrial Instrument:Power Frequency Tester
This equipment is used for testing the insulation properties of EUT
Specification: Max output potential:
10KV (Adjustable) Short circuit protection Program able stress
time LCD Based
interface / counter / voltage indicator
Industrial Instrument:Rain Fall Simulator
Rain fall tester is used for simulating the raining scenario for EUT.
Its use is to check and verify the sealing of EUT
Industrial Instrument:Short Time over Current Tester
It is used for checking the EUT under severe short circuit and over load conditions.
Specification: Output current range:
1200A / 3000A Time of pulse: 10ms Purely inductive
solution