Post on 04-Nov-2014
description
transcript
Asif HaiderHabib Awan
OPTIMIZATION
Optimization is intended to provide the best network quality using available
resources as efficiently as possible
INTRODUCTION TO TEMS
• Drive testing is the most common and maybe the best way to analyze Network performance.
• Drive testing is basically recording measurement data which can also be analyzed afterwards.
• It gives idea about what’s happening with a subscriber point of view.
CONTENTS
The information provided by TEMS is displayed in status windows. This information includes
• cell identity, base station identity code, BCCH carrier ARFCN, mobile country code, mobile network code and the location area code of the serving cell.
• There is also information about RxLev, BSIC and ARFCN for up to six neighboring cells;
CONTENTS
• channel number(s), timeslot number, channel type hopping channel indication, mobile allocation index offset and hopping sequence
• RxLev, RxQual, FER, DTX down link, TEMS Speech Quality Index (SQI), timing advance (TA), TX Power, radio link timeout counter and C/A
• parameters for the radio environment.• The signal strength, RxQual, C/A, TA, TX Power, TEMS
SQI and FER of the serving cell and signal strength for two of the neighboring cells can also be displayed graphically in a window.
USING SOFTWARE
• Tailored settings
• Default tabs
• Basic windows
• Maps—gst
• Recording properties
• Exporting log files
• Report generation
ANALYSIS OF LOG FILES
Analysis is the most important part. Lets look at some of the cases.
• Dropped call - Nbr not defined
• Dropped call – RL Timer expires
• HO Failure
Lack of Dominant Server
Signals of more than one cell can be reaching a spot with low level causing ping pong handovers. This might happen because the MS is located on the cell borders and there is no any best server to keep the call.
Drop Call due to Bad Coverage
• Call is dropped because of poor coverage.
• The signal level goes down below the minimum signal level that system could carry on
Bad Quality due to Signal Strength
• FER is Bad
• FER is good implies no obviuos interference in the area.
LAYER 3 MESSAGES
Layer 3 Messages
• SYS INFO• Measurement Reports• Sync Messages• Paging Messages• Handover• Call Setup
etc
IDLE
DEDIC
Measurement Reports
SYNC CHANNEL INFO
Paging Request Message
QUESTIONS
• REFERENCES
• TEMS Log File Analysis
• ARI-Nortel
• Nokia BSS parameters