Post on 25-Sep-2020
transcript
THERMOSTAT HOUSING REPLACEMENT
Removal Procedure
IMPORTANT: The thermostat is not serviceable separately. The thermostat housing (water pump inlet) and thermostat must be replaced as an assembly.
Drain the cooling system/engine block. Refer to Draining and Filling Cooling System. 1.
Loosen the air cleaner outlet duct clamps at the throttle body and at the Mass airflow (MAF) sensor.
2.
Page 1 of 6ENGINE COOLING -2003 Hummer H2
7/28/2013http://www.ondemand5.com/mric/common/asp/printart.aspx
Edited with the trial version of Foxit Advanced PDF Editor
To remove this notice, visit:www.foxitsoftware.com/shopping
Fig. 59: MAF/IAT Sensor & Air Cleaner Assembly Courtesy of GENERAL MOTORS CORP.
Remove the air cleaner outlet duct. 3.
Page 2 of 6ENGINE COOLING -2003 Hummer H2
7/28/2013http://www.ondemand5.com/mric/common/asp/printart.aspx
Edited with the trial version of Foxit Advanced PDF Editor
To remove this notice, visit:www.foxitsoftware.com/shopping
Fig. 60: View Of Water Pump Inlet & Thermostat Housing Courtesy of GENERAL MOTORS CORP.
Remove the radiator outlet hose. 4.
Remove the thermostat housing bolts. 5.
Remove the thermostat housing from the water pump.6.
Installation Procedure
Install the thermostat housing to the water pump. 1.
Page 3 of 6ENGINE COOLING -2003 Hummer H2
7/28/2013http://www.ondemand5.com/mric/common/asp/printart.aspx
Edited with the trial version of Foxit Advanced PDF Editor
To remove this notice, visit:www.foxitsoftware.com/shopping
Fig. 61: View Of Water Pump Inlet & Thermostat Housing Courtesy of GENERAL MOTORS CORP.
NOTE: Refer to FASTENER NOTICE .
Install the thermostat housing bolts. 2.
Tighten: Tighten the bolts to 15 N.m (11 lb ft).
Install the radiator outlet hose. 3.
Page 4 of 6ENGINE COOLING -2003 Hummer H2
7/28/2013http://www.ondemand5.com/mric/common/asp/printart.aspx
Edited with the trial version of Foxit Advanced PDF Editor
To remove this notice, visit:www.foxitsoftware.com/shopping
Fig. 62: MAF/IAT Sensor & Air Cleaner Assembly Courtesy of GENERAL MOTORS CORP.
Install the air cleaner outlet duct. 4.
Page 5 of 6ENGINE COOLING -2003 Hummer H2
7/28/2013http://www.ondemand5.com/mric/common/asp/printart.aspx
Edited with the trial version of Foxit Advanced PDF Editor
To remove this notice, visit:www.foxitsoftware.com/shopping
Install the air cleaner outlet duct clamps at the throttle body and at the Mass airflow (MAF) sensor.
5.
Tighten: Tighten the air cleaner outlet duct clamp screws to 7 N.m (62 lb in).
Fill the cooling system. Refer to Draining and Filling Cooling System6.
© 2008 Mitchell Repair Information Co., LLC.
Page 6 of 6ENGINE COOLING -2003 Hummer H2
7/28/2013http://www.ondemand5.com/mric/common/asp/printart.aspx
Edited with the trial version of Foxit Advanced PDF Editor
To remove this notice, visit:www.foxitsoftware.com/shopping