Post on 13-Nov-2020
transcript
Industry Water Waste Water Energy Building Services Mining
Pumps n Valves n Systems
UPA – Submersible borehole pump for well diameters of 200 mm (8 inches) and above
Applications: n General water supplyn Irrigation and spray irrigationn Pressure boostingn Lowering of groundwatern Miningn Offshore applications and tank systemsn Sprinkler and fountain systems
Further information: www.ksb.com/products
3400
.025
/4-1
0 / 0
7.09
/ Su
bje
ct t
o t
ech
nic
al m
od
ific
atio
n w
ith
ou
t p
rio
r n
oti
ce. /
© K
SB A
ktie
ng
esel
lsch
aft
2009
Trouble-free operationEven in demanding applications the maintenance-free
encapsulated bearing protects the shaft and bearing area
from solids. For fluids with high sand content, we offer
a high wear resistant material variant.
Increased service life of motorsThe mechanical seal in carbon, ceramic or SiC/SiC material
combination prevents any leakage of motor fluid into the
pumped liquid thus preventing contamination. The pump sets
are selected for maximum performance, thus protecting the
motors against overload.
Reliable pressure balancing systemn Optimum rubber expansion diaphragm designn Enables installation at very low depths
High operating reliability and long service lifeThe check valve with anti-blockage check plate closes quickly
and silently, and reduces water hammer. The water-lubricated
self-aligning tilting-pad journal bearing in the motor ensures
correct bearing function even under high loads.
Tried and tested thrust bearingn Water-lubricated self-aligning tilting-pad journal bearingn No-maintenance design suitable for maximum load-carrying
capacity under continuous operation conditionsn New materials combination (stainless steel/carbon) for high
safety factor
UPA – Submersible borehole pump for well diameters of 200 mm (8 inches) and above
Technical data 200B/250C 300/350
max. capacity 330 840 m3/h
(50 Hz) 1,210 3,080 gpm (UK)
max. capacity 400 1,010 m3/h
(60 Hz) 1,466 3,703 gpm (UK)
max. discharge head 460 480 m
(50 Hz) 1,509 1,575 ft
max. discharge head 440 480 m
(60 Hz) 1,445 1,575 ft
Max. Speed (50Hz) 2,900 2,900 min-1
Max. Speed (60Hz) 3,500 3,500 min-1
Max. fluid
50 50 ˚C
temperature* 122 122 ˚F
*Higher temperature applications available upon request
Materials UPA 200B UPA 250C UPA 300/350
Pump Cast iron/ Cast iron/ Cast iron/
casing bronze bronze bronze
Impeller Glass-fibre reinforced bronze bronze
Noryl oder bronze
Pump Cr-steel/ Cr-steel/ Cr-steel/
shaft CrNiMo-Steel CrNiMo-steel CrNiMo-steel
Motor Cast iron/ Cast iron/ Cast iron/
housing CrNiMo-steel CrNiMo-steel CrNiMo-steel
Motor CrNi-steel/ CrNi-steel/ CrNiMo-steel
shaft CrNiMo-steel CrNiMo-steel
Stator CrNi-steel/ CrNi-steel/ CrNiMo-steel
case CrNiMo-steel CrNiMo-steel
Other variants on request
Automation available
KSB Aktiengesellschaft Johann-Klein-Straße 967225 Frankenthal (Germany)www.ksb.com