Vessel Wash Wastewater Management – Options for Marinas Presented by: Michael J. Danko New Jersey...

Post on 29-Jan-2016

214 views 0 download

Tags:

transcript

Vessel Wash Wastewater Management – Options for

MarinasPresented by:

Michael J. Danko New Jersey Sea Grant Consortium

Virginia Marine Trades Conference

November 10, 2015

Wastewater Composition• Generally classified as industrial

wastewater

• Keep the lead out! To avoid hazardous waste classification

• Large solids - Paint chips, barnacles, etc

• Metals - Solid and dissolved

• Bacteria

• pH - Hull cleaners can lower pH levels. Low pH can increase dissolved metals

Wastewater Management Goals • Number of boats washed annually

• Average length of the vessels washed

• Estimated volume of freshwater used

• Type of bottom paint used on the majority of boats at your facility

Wastewater Mgmt Goals cont. • Estimate volume of wastewater

collected• Average time spent washing boat

bottoms is 15-20 minutes • Average volume recovered is 40

gallons per boat • Water/sewage charges that may

apply• Contact local sewer authority to

discuss options

Step One – Collection System

• Consists of a wash pad, sump and storage tank; approximately $15,000 to install.

• Wash pad size determined by length of vessels handled at your facility.• Cost of pad can vary

widely

• Temporary pads are a viable option for smaller facilities

Collection System cont.

• Recommend a dual-chambered sump capable of holding 300-400 gallons.

• Temporary storage is recommended; size will vary depending on treatment and/or disposal method.

• Stormwater diversion• Check State regulations to determine

legal disposal methods• Cover for sump• Divert stormwater to surface or

ground water using additional valves and piping

Step Two – Choosing A Disposal or Treatment Method

• Option A – On-site storage with no treatment, wastewater is hauled away for proper disposal

• Option B - On-site treatment, treated wastewater is recycled or disposed of into a sewer line

• Primary treatment

• Secondary treatment

Step Two – Choosing A Disposal or Treatment Method

cont.• Option A – Store the wastewater and have it hauled away for proper disposal• Approximate cost - $15,000 for collection

system and storage tank; $0.84 – $1.13/gallon for wastewater disposal

• Recommend 2,000-gallon storage tank

• Advantages - low initial investment, minimal maintenance, provides data to assess if on-site treatment will be cost-effective

• Disadvantages - potential for high disposal costs, water use remains the same

• Option B – On-site treatment• System must be located in a heated

shed• Marina operators must evaluate the

acceptable level of treatment for recycling or discharge to a sanitary sewer line

Step Two – Choosing A Disposal or Treatment Method cont.

• Option B - Primary Treatment• Mechanical filtration, cyclonic action or other

similar means to remove solids• Approximate cost - $27,000 ($15,000 for

collection system; $12,000 for treatment system)

• Cost of the system increases when treatment options like sanitization and pH adjustment are added

• Advantages- moderate costs and option to recycle treated wastewater

• Disadvantages – potential for high maintenance costs; need to monitor contaminant levels and periodically purge system

Step Two – Choosing A Disposal or Treatment Method cont.

• Option B - Advanced Treatment• Electrocoagulation or similar methods

that remove solid and dissolved metals• Total cost is approximately $32,000

($15,000 for the collection system; $17,000 for the treatment system)

• Advantages- moderate cost, wastewater can be recycled without the need to purge, will most likely meet requirements for discharge to a sanitary sewer, maintenance costs are moderate

• Disadvantages – higher initial investment

Step Two – Choosing A Disposal or Treatment Method cont.

BMPs• Purge systems that use filters, cyclonic

action or other similar means as the primary method of preventing the build-up of dissolved metals

• Contract with a laboratory for weekly bacterial and pH analysis initially to determine levels and adjust purging schedule as needed

• Remove or cover all sacrificial anodes when pressure washing

• Products used to remove growth at the water line can adversely lower the pH in the wastewater

Mike Danko 732-872-1300 ext. 29 or mdanko@njseagrant.org

NJSeaGrant.org/extension/recreational-fishing/vessel-wastewater-management/

For More Information