Wall Mount Guitar Holder - Kreg Tool

transcript

Wall Mount Guitar Holder

This simple wall mount guitar holder is perfect for displaying your guitars without taking up floor space. Simple design

means they look rad even if theres no guitar hung.

Difficulty

ToolsKreg Tools

Kreg Pocket-Hole Jig® 720

Other Tools

Miter Saw

Scroll Saw

Drill (cordless)

MaterialsWood Products

Board , 1x4 , 12"1

Hardware & Supplies

Pocket Screws 1 1/4"2

2" Black Screws For Mounting2

Ebony Stain1

Satin Clear Coat1

Cut List & PartsWall Mount , 3/4" X 3 1/2" X 5 1/2"1

Guitar Holder , 3/4" X 3 1/2" X 4 1/2"1

DirectionsPlansThese plans illustrate the sizing and cuts for each piece in the holder.1

Cut WoodCut the board (I used maple) into two pieces, one 5 1/2" and one 4 1/2"2

Drill Pocket HolesDrill two pocket holes according to Kreg Jig directions in the longer piece of wood as shown in plans.3

Cut Guitar Neck HoldUse a jigsaw or scroll saw to cut a space for your guitar neck. Cut according to the size of your guitar, making it no larger

than the bottom of the headstock.

Attach Wood PiecesUse the pocket hole screws and attach the two pieces of wood as shown.5

Sand, Stain, SealSand, stain and seal your guitar holders. I used Ebony stain and a satin poly.6

Mount to wallUsing wall anchors if necessary, sink two screws through the top half of the wall mount into the wall.7

Documents