Summary

This is a space saver for your wardrobe. The hook can move freely andlock into 3 positions, you can also turn the hook 360°. There are only littlesupports needed for the print and the hook joint is printed in place, so noassembly will be needed there.

Assembly guide:

Print the hook and the main body, you can also use the 3mf or gcodefile which is already pre configured.Turn the hook joint a little to set it free, it should move easilyafterwards.The hook can be guided in to the main body through the opening.

I recommend to use the .gcode or .3mf file as this is already correctlyorientated and sliced.

+++++++++++++++++++++++++++++++++++++++++++++++++

Nils Kal

Wardrobe SpaceSaver

VIEW IN BROWSER

updated 23. 2. 2020 | published 23. 2. 2020

1.

2.

3.

5.07 hrs

1 pcs

f

0.20 mm

k

0.40 mm

h

1

65.00 g

d

MK3/S

Print Files (.gcode) DOWNLOAD ALL FILES

5.1 MB

5.07 hrs f 0.20 mm k 0.40 mm h PLA 65.20 g d MK3/S

updated 23. 2. 2020

Model Files (.stl, .3mf, .obj, .amf) DOWNLOAD ALL FILES

283.7 KBupdated 23. 2. 2020

196.6 KBupdated 23. 2. 2020

If you like this file or need some adjustments feel free to leave a comment. A rating or tip is also

welcome and may check out my other designs!

Happy printing!

Household > Bedroom

wardrobe organizer hook closet

Watch your slicer to correctly bridge for the main body, may change thebridging angle (I also did this for the 3mf and gcode)

wardrobe-space-saver_02mm_pla_mk3s_5h4m.gcode

main-body.stl

wardrobe-space-saver.3mf

489.0 KBupdated 23. 2. 2020

License

This work is licensed under a Creative Commons (4.0 International License)

Attribution-NonCommercial

✖ | Sharing without ATTRIBUTION ✔ | Remix Culture allowed ✖ | Commercial Use ✖ | Free Cultural Works ✖ | Meets Open Definition

hook.stl