Post on 20-Oct-2015
description
transcript
a LOT NUMBER:WHALEN PURCHA—F—r—I‑
Audio Component TowerModel# BBAT27TC
ADULT ASSEMBLY REQUIREDIf you have any questions regarding assembly or if you are missing parts, do not return thisitem to the Retailer Store. Please call our toll free customer service number and have yourinstructions and parts list ready to provide the model name, part name or factory number:
1-866-942-5362 8:30 am. -4:30 pm. PST, Monday-FridayONLINE: www.whalenfurniture.com EMAIL: 9arts@whalenfurniture.com
Video Instruction GuidesGo to httgzllwhalenshowuhow.com to viewstep-by—stepinstructionalvideos for assembling and installing your product. Enter the followingproduct number on the Shothow homepage.
BBAT27TC
THIS INSTRUCTIONBOOKLETCONTAINS IMPORTANT SAFETY INFORMATION.PLEASE READAND KEEP FOR FUTURE REFERENCE.Whalen Furniture Mfg. Inc. Page 1 Factory No. 56-12089
Model # BBAT27TCQUALITY GUARANTEE
We are confident that you willbe delighted withyourWhalen Furniture purchase.Should this product be defective in workmanship or materials or fail under normaluse, we willrepair or replace it for up to one (1) year from the date of purchase.EveryWhalen Furniture product is designed to meet your highest expectations. Weguarantee that you willimmediately see the value of our fine furniture,This warranty gives you specific legal rights and you may also have other rightswhichvaryfromState to State.
Customer Service: 1-866-942-53628:30 am. -4:30 pm. PST, Monday to Friday
www.whalenfurniture.com
I MAXIMUM RECOMMENDED WEIGHT LOADS
MANUFACTURER:Whalen FurnitureCATALOG: Audio Component Tower (BBAT27TC)DATEOFMANUFACTURE: September,2013MADE INCHINA
i
FITS UP TOMOST32" FLAT PANEL TVsMAXIMUMLOAD 80 lb. (36.3 kg)
MAX/MUMLOAD50 lb. (22.7 kg)
- T H I S UNIT IS NOT INTENDED FOR USE WITH CRT TVS. USE ONLYWITH FLAT PANEL TVS AND AUDIONIDEO EQUIPMENT MEETING RECOMMENDEDSIZEANDWEIGHT LIMITS. NEVER USEWITH LARGER/HEAVIERTHAN RECOMMENDEDFLATPANEL TVS OR EQUIPMENT. TO AVOID INSTABILITY, PLACE FLAT PANEL TV IN CENTREOF UNIT; CRT TVS, IMPROPERLY POSITIONEDFLAT PANEL TVS, OR FLAT PANEL TVSOR OTHER EQUIPMENT THAT EXCEED RECOMMENDED SIZE AND WEIGHT LIMITSCOULD FALL OFFOR BREAKTHE UNIT, CAUSINGPOSSIBLESERIOUS INJURY.
Please call for replacement parts orassistance: 1-866-942-5362Whalen Furniture Mfg. Inc. Page2 FactoryNo. 56-12089
Model# BBAT27TCParts and Hardware List
Please read completely through the instructions and verify that all parts listed are presentbefore beginning assembly.
8- Second ShelfFrame (1) 0- ThirdShelf Frame (1)
E—Spine (1) F- LeftLeg (1)
6- Right Leg (1) H- Top Glass (1) |- Second Glass Shelf (1)
J- Third Glass Shelf (1) K- BottomGlass Shelf (1)
9 MW till-WW @(1) Suction Cup (2) 3/ " Bolt (3) 1-1/4" Bolt (4) Lock Washer(12+1extra) (10+1 extra) (8+1 extra) (18+1 extra)
@ a e a(5) FlatWasher (Q)GlassRiser AllenWrench Touch-up Pen Tipping RestraintHardwareKit (1)(18+1 extra) (5+1 extra) (2) (1) (Inside Plastic Bag)
Tools reguired: Allen Wrench (provided).Please call for replacement parts or assistance: 1-866-942-5362Whalen Furniture Mfg. Inc. Page 3 Factory No. 56-12089
Model # BBAT27TCAssembly Instructions
Note: Please do not full ti hten Ilbol uniI ou finish ssemblin all arts. Oncea sembled0 backand full ti hten all bolts. Thiswillmakeit easierdun'n assembl of unit.
1. Unpackthe unit and confirm that you have all the hardware and required parts listed.
2. Locate Spine (E) on a level and protective surface with 3 oval holes facing up as shown indetail #1.
3. Align the pre-drilled holes of 4 Shelf Frames (A, B, C & D) at back rail with the threadedinserts on the Spine (E) in place. Make sure the flush edges will point up after assembly.Attach using eight 1-1/4" Bolts (3) with Washers (4 & 5) into the pre-drilled holes. Tightenthe bolts with the AllenWrench provided. See detail #1.
Detail#1
Bottom
Required hardware in this stepDescription: (3) 1-1/4”Bolt (4)LockWasher (5) FlatWasher
i @Sketch
Qty. (8 pcs) ' (8 pcs) (8 pcs)Tools reguired: Allenwrench
Please call for replacement parts orassistance: 1-866-942-5362Whalen Furniture Mfg.Inc. Page 4 Factory No. 56-12089
Model # BBAT27TCAssembly Instructions
4. Pick up Right Leg (G) and align the back inserted nuts with the end brackets on all ShelfFrames (A. B, C a D)simultaneously. Insert and screw the 3/4” Bolts (2) with Washers (4 &5) through the and brackets into the Leg as shown in detail #2. DO NOT tighten the bolts.Ensure the top of the leg is flush with Top Shelf Frame (A).
5. Repeat last step to install Left Leg (F) at the other end. Make sure the gap and offsetsbetween the wooden front rail of Top Shelf Frame (A) and both Legs are the same. Loosenthe bolts on the end bracketsandWood FrontRail and adjust if necessary.
Required hardware in this step
Description: (2) 3/4"Bolt (4) LockWasher (5) FlatWasher
Qty. (10pcs) (10pcs) (10pcs)
Tools muired: Allen wrench
Please call for replacement parts or assistance: 1-866-942-5362Whalen Furniture Mfg. Inc. Page 5 Factory No. 56-12089
Model # BBAT27TCAssembly Instructions
6. Stand the unit upright. Go back and tighten all the boltswith the AllenWrench provided.7. Put Suction Cups (1) firmly into top holes of the Lower Shelf Frame (B, C & D) as shown in
detail #3. Make sure that the Suction Cups go all the way into the pre-drilled holes toprevent the glass shelf from falling and getting damage.
8. Screw the Glass Risers (6) all the way into the top holes of Top Shelf Frame (A) and Left &Right Leg (F & G). See detail #3A.
9. Place the Glass Shelves & Top Glass (H) in place begin with Bottom Glass Shelf (K) asshown in detail #3. Make sure the glass is properly centered and the black side of glass isdown. Also, be sure to press down evenly and firmly each shelf onto the Suction Cups tomakesure they securely rest onto the Suction Cups.Note: Make sure that the glass sits correctly. If glass is scratched you can minimize thedamageby using a BLACKmarker andfilling in scratched area from underneath.
10.ln case of uneven floor, Floor Levelers are provided at the bottom of both Legs (F & G).Simply tilt the unit back and raise or lower floor levelers by hand to correct tilting. until theunit is level. See detail #3A. Note: When adjusting the height and tilting the unit make surethat you ask for assistance to preventthe glass from falling.
\’ Jx/ (Sid
Required hardware in this stepDescription: (1) SuctionCup (6)Glass Riser
Sketch QQty. (12 pcs) (5 pcs)
Pleasecall for replacement partsor assistance:1-866—942-5362Whalen Furniture Mfg. Inc. Page6 Factory No. 56-12089
Model# BBAT27TCTIPPING RESTRAINT HARDWARE
Note:We have included one Tipping Restraint Hardware bag for this unit.When properly installed, this restraint can provide protection against the unexpected tippingof the unit due to small tremors, bumps or climbing. We strongly recommend mounting thishardware to a wall stud and your unit when installing.Pleasecarefully read the instructions printed on the plastic bag containingTippingRestraintHardware Kit.Note: You must install the Tippinq Restraint Hardware with the unit in use to preventanv accidents or damacieto the unit.
Tools required: Allen Wrench (provided). Phillips Screwdriver, Mallet, Power Drill, and 3/8" Drill Bit.A Touch~up Pen has been provided to repair any small nicks or scratches that may occurduring assembly or shipping.
Your assembly should now be complete.Thank you for your purchase.
@WHALEN°Please call for replacement partsor assistance:1-866-942—5362Whalen Furniture Mfg. Inc. Page 7 Factory No. 56-12089
=u<OCmeU._.0NmOCmmH>Z<Ukfld_u_.m>mmcmm%Im.Em...wmr0<<
Mnmggfldi
._:_.
nww>4ufldn.n.xr
.wm>._.~.~._.0.w.<:1_~
;ww>._.~fl._.05.dm
m»ww>4.nu._.0-u.w
mfl
~mw>4NN.—.O.andmm
nwm>dnjdhuwm
m
;wm>._.N:.O.m.m
»wm>._.NN._.O-o.._.Q
.mm>._.~.3.0..—
9QO
3ENE—43.0...
fflmm
»ww>._.u.\._.OL
N.m0m
..ww>.qn.3.n-..90:
>56
00:60sz
4029
3.994349
.5:ranEngr3
icons:133an:
42.
mg:
3.930
mono—E
mg:
133»
423mg:
“3:5
950:.
26:
13:5
mum...»
40....
05mm
manoan
0.3m
Man:
.213
93.3
mg:
W030:—
0_~mw
mam:
Coin—
n8:uEEm
R
’ww>._.Nu._.OLh-w
zw
nWU>...NN._.O
k_uk_
33w
‘53..
no.»
‘stfidedk.
9.52
.ww>._.~udnh«.2
gmm>._.MN._.O.._a1mn
.ww>4.~3.050.0w
duh—
$193-22
mi:
mo.»
root
.2332
In.Ema—5..
mango:
Oct
0.9353..
>=a=
5:25...
num>dnudnbf4mzx
.2356.3335»
139,335.
nww>4nqdnbuuwcv
.ww>._.~3.0.~w.mr
.ww>._.nu._.0.nu.0_u0
.ww>._.~3.0.~a.vmo
.ww>dm.\40.~u.mmn
4053...“.
v2.
109‘
r312.
O<»_
Emma."
03332
Emma."
man02.
mumam
man
One