Post on 05-Jan-2016
transcript
Your Project:• Create one HUMP mold platter, bowl or plate with feet and
handle(s) (slab or coils/designs draped over)• Create one SLUMP mold platter, bowl or plate with feet and
handle(s) (slab or coils/designs pressed into)• Mold projects can have the same theme (series), or different
themes. • Must include an interesting texture or design/pattern through
addition or subtraction of clay that enhances the overall design• Size: Nothing bigger than a pottery wheel bat• If you finish early, you can choose to create lids, or possibly
another molded piece of your choosing (same size requirements) (You will be glazing these molds with dinnerware-safe glazes)
Small slab hearts layered and pressed into a bowl to create a slump mold
Large slab
pressed into or onto a form
(edges cut
away)
Coils/slab strips pressed into/onto a form
This would have been made as a HUMP mold. You can tell because all the additive pieces are on the outside.
This is a platter (shallow compared to a bowl)
Check out those handles!
Which do you like? Clean and modern or ornate and detailed?
Texture & Designs/Patterns
Feet
Finishing: You will be glazing these platters/bowls with dinnerware safe glazes
(so you can actually use them for food!)
Slump/Hump Molds
Square Platter Slump Mold (1:37)Square platter hump mold (1:26)Adding feet to your mold (1:31)
Finishing your mold (1:18)paper plate slump mold (4:57)
HOMEWORKDue tomorrow:
• 5 idea sketches• 2 different objects to mold from