Post on 11-Jan-2016
description
transcript
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
ZyGMA7 Outdoor WirelessCPE/AP Series
2011/07/01
Solwise Ltdwww.solwise.co.uksales@solwise.co.uk
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
Outdoor Wireless
5G 2.4G 2.4G
Z9050L-ANZ9050-ANZ9024-BGNZ9024L-BGN-v2
Z9000-R1Z9000-R2Z9500-5G23
Please refer detail spec in www.zygma7.com
CPE/AP Series
BACKBONE Series
5G
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
Application Arena
Up to 2km
Up to 6kmUp to 10km
Up to 30km (by Multi-hops)
CPE/AP for Local Coverage BACKBONE for Backbone & Backhaul
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
Affordable Infrastructure
Affordable InfrastructureRural Networking
Long-range Wireless up to 5 km (by AP/CPE)up to 10 km (by BACKBONE)up to 30 km (by multiple BACKBONE)
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
CPE/AP Series
2011/07/01
Solwise Ltdwww.solwise.co.uksales@solwise.co.uk
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
CPE/AP Series
• Featura N5 (Z9050-AN)• Fighter N5 (Z9050L-AN)• Featura N2 (Z9024-BGN)• Fighter N2 (Z9024L-BGN-v
2)
5G 2.4G 2.4G
Z9050L-ANZ9050-ANZ9024-BGNZ9024L-BGN-v2
CPE/AP Series
5G
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
CPE/AP Series
• The CPE/AP products is used as – the CPE of household– the AP for local coverage, or– a set of APs for coverage
• Long-distance point-to-point applications are also supported– the typical distance ranges from 1-5 kilometers, depends on the
antenna and installation setup.• Typical Application Scenarios:
– Campus Networking– Clients of subscribers of WISP– Wireless Connection for IP Surveillance
• Regulation Compliance: – CE Certificate
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
n
AP Mode
Z9050-AN
as AP
Internet
AP Mode
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
CPE Mode
CPE Mode
Z9050-AN
as CPE
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
WDS/Bridge Mode
Z9050-AN
WDS Bridge
Z9050-AN
WDS Bridge
Z9050-AN
WDS Bridge
WDS/Bridge Mode
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
Benchmark Test TopologyZ9050-AN
with 16dBi 5GHz AntennaAs Base Station
6KM4KM
2KM1KM Test 1
As CPETest 2
As CPETest 3
As CPE
Test 4As CPE
Move to
Move to
Move to
Benchmark Test Topology
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
Long-Range Outdoor Wireless
802.11an in 5GHz Band
Long-Range Outdoor Wireless: Design Guideline
Coverage Angel = 35 degree for Internal Antenna
Max Distance= 5km to 6km
External Antenna Connector (2x2)Is Available
1
23A
3B4
Max Throughput = 35~80 Mbps (depends on Distance)
Z9050-AN
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
Long-Range Outdoor Wireless
Coverage Angel = 120 degree for Internal Antenna Max Distance
= 10km to 12 km
802.1bgn in 2.4GHz Band
External Antenna ConnectorIs Available
1
2
3A
3B
4
Z9024-BGN
Max Throughput = 18~73 Mbps (depends on Distance)
Long-Range Outdoor Wireless: Design Guideline
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
PoE out-to-device
Long-Range Outdoor Wireless: PoEZ9050-AN
PoE Out-to-device: 12V(optional Power Adapter 15V/2AIs Available for Z9050-AN)
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
Multiple BSSID
• Feature Description– Allows you to create multiple network n
ames/SSIDs on one AP with individual security and broadcast settings.
– Additionally, you can assign the virtual SSIDs to different VLANs to provide segregation between the virtual wireless networks.
• Benefits– Flexible network deployment
– Channel conservation
– Capital expenditure reduction
Multiple BSSIDZ9050-AN
SSID=“Guest”Security=WEPBSSID=AP Mac Address
SSID=“Employee”Security=WAPBSSID=AP Mac Address
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
LAN2LAN CPE
• Feature Description– Station WDS allows to connect to
the Access Point which is operating in WDS mode.
– Station WDS mode enables packet forwarding at layer 2 level.
• Benefits– Improved performance – Fully transparent for all the layer 2
protocols
LAN2LAN CPEZ9050-AN
WDS AP
WDS Client
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
TDM Coordination• Feature Description
– TCF explicitly uses information on the number of active stations to eliminate the contention period in the DCF (distributed coordination function) of IEEE 802.11. TCF can improve overall throughput and provide fair sharing of resources among active stations.
– It ensures all the clients getting access in a fair manner, and avoids the bandwidth from being occupied by clients with heavy traffic.
• Benefits– Offering fair bandwidth to clients– Solving hidden-node issue– Improved performance
TDM CoordinationZ9050-AN
Base Station
up/down: 1/1Mbps
up/down: 10/10Mbps
Internet
up/down: 20/20 Mbps
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
Power Adjustment in 1dB Increments
• Feature Description– Allows to adjust output power in
1dBm increments
• Benefits– Enable to configure the exact
desired output power value
18
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
HTTPS/SSH
• Feature Description– Hyper Text Transfer Protocol
Secure (HTTPS) is a secure version of the Hyper Text Transfer Protocol (http). HTTPS encrypts and decrypts user page requests.
– The use of HTTPS protects against eavesdropping and attacks.
– SSH Secure Shell provides users with a secure, encrypted mechanism to log into systems and transfer files; it can be viewed as a secure replacement for FTP.
• Benefits– Makes configuration and data
more secure.
ServerPublic Key
Private KeyClient
Encrypted
Data
in Internet
HTTPS
SSH
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
Featura N5 (Z9050-AN)• Wireless Mode for P2P & P2MP Configuration
– AP– Wireless Client– Bridge– AP Repeater– WDS configuration in Bridge Mode or AP Repeater Mode
• Network Mode– Bridge– Router
• Space in Meter/ACK Timeout– By simply specifying distance of the two nodes, the Z9050-AN can automatically self-adjust the proper
ACK timeout value to decrease the chances of data retransmission at long distance.• WLAN Isolation/Wireless Separation
– prevent wireless client from access each other, i.e. the user can not see others who are associated with the same AP. For example, User A and User B live in neighborhood, and subscribe the internet service from WISP company XYZ, XYZ will set the WLAN isolation mode to provide service to A and B by the same AP, but XYZ does not expect A knowing about B or B knowing about A. In this situation, the WLAN isolation is good for XYZ.
• Max Station Num– Available only under AP mode, it defines the maximum amount of wireless clients allowed to be
connected.• 802.1q VLAN• Rate Limiting to Ethernet 1 and Ethernet 2
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
Featura N5 (Z9050-AN)• WMM Support
– WMM (Wi-Fi Multimedia) is a subset of 802.11e. It allows wireless communication to define a priority limit on the basis of data type under AP mode only, thus those time-sensitive data, like video/audio data, may own a higher priority than common one. To enable WMM, the wireless client should also support it.
• Short GI(Guard Interval)– Under 802.11n mode, enable it to obtain better data rate if there is no negativ
e compatibility issue.• A-MPDU/A-MSDU Aggregation (Frame Aggregation)
– The data rate of your CPE except wireless client mode could be enhanced greatly with this option enabled; however, if your wireless clients don’t support A-MPDU/A-MSDU aggregation, it is not recommended to enable it.
• IGMP Snooping– IGMP snooping is the process of listening to IGMP network traffic. By enablin
g IGMP snooping, the AP will listen to IGMP membership reports, queries and leave messages to identify the ports that are members of multicast groups. Multicast traffic will only be forwarded to ports identified as members of the specific multicast group or groups.
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
Featura N5 (Z9050-AN)• Access Control List• Link Integration
– Available under AP/Bridge/AP repeater mode, it monitors the connection on the Ethernet port. It can inform the associating wireless clients as soon as the disconnection occurs.
• Disable Broadcast SSID from being scanned– In AP mode, hiding network name is necessary when you are in a wireless
environment that may have potential risk. By disabling broadcast SSID, the STA cannot scan and find the IEEE 802.11a/n Wireless Outdoor CPE, so that malicious attack by some illegal STA could be avoided.
• Spanning Tree Protocol• HT Protect
– Enable HT (High Throughput) protect to ensure HT transmission with MAC mechanism. Under 802.11n mode, wireless client can be divided into HT STA and Non-HT STA, among which the one with HT protect enabled gets higher throughput.
• External Antenna• Antenna Alignment with RSSI and Signal Level Display
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
Featura N5 (Z9050-AN)• SNMP V3• Ping Watchdog for heart-beat check
– IP Address to Ping– Ping Interval– Startup Delay– Failure Count to Reboot
• GPS Coordinate Settings
• Remote Firmware Upgrade• Configuration File Backup/Restore• Manual Remote Reboot• Disable Wireless LAN Interface
– the wireless module of the CPE will stop working and no wireless device can connect to it.
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
Network Activity Monitor
• Feature Description– Allows to monitor the current Wir
eless and Ethernet real throughput in graphical form on the Web User Interface
• Benefits– Easy and convenient to monito
r the performance instead of using other throughput test tools such as Chariot or Microtik
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
Speed Test
• Feature Description– Allows to test the current data
transmission (TX) and data reception (RX) rate with the remote CPE/AP unit.
• Benefits– Easy and convenient monitoring
of the data rate between the bridges
25
Encrypt Ixchariot IPerf Speed Test FTP MemoTX RX TX+RX TX RX TX+RX TX RX TX+RX TX RX TX+RX
None 93.215 93.657 135.433 41.5 42.3 51.3 35.6 36 38.2 71.768 90.68 N/A Mbps, PTP, HT40
Note: Benchmark programs have various figures for the Z9050-AN. These are the referenced numbers for each benchmarks
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
Station Monitor
• Feature Description– Allows to monitor the current
status of the associated client in details
• Benefits– Robust diagnosis and
monitoring
26
Station Monitor
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
Features of Fighter N2/N5
• Reset button on PoE Injector for Factory-default– It has big advantages after
the device is installed. User need not to take off the device for resetting to factory default.
• Software Selectable; Connector for External Antenna
• Wide operating temperature: -30~55 deg
• IP65 Protection
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
Features of Fighter N2/N5
• Reset button on PoE Injector for Factory-default
• SMA Connector for External Antenna
• Wide operating temperature: -30~55 ℃
• IP65 Protection
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
ApplicationExamples
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
Campus Wireless Network
Dormitory
Classroom
Central Building
Campus Network
Internet
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
Z9024-BGN
as AP
Internet
Wireless for IP Surveillance
IP CAM
& CPEIP CAM
& CPE
IP CAM
& CPE
IP CAM
& CPE
Wireless for IP Surveillance
Solwise Ltdwww.solwise.co.uk
sales@solwise.co.uk
OWL Application Summary